The most likely case would be that air somehow got into the line. try bleeding the clutch fluid, while making sure that the level in the reservoir does not get low.
You need to bleed the clutch
The Clutch slave cylinder is located on the passenger side of the bellhousing.I recommend to replace the Clutch Master cylinder also;if either one is replaced , the other will fail in no time.
did you bleed it? try raising it from the differential to get a good bleed on your clutch. and if that doesn't work make sure the rod from the pedal to the actual master cylinder is screwed on. if it isn't, ur jsut kicking a pedal.
Hydraulic clutch on that model is not ajustable. You either have a bad clutch slave cylinder, Or the clutch and pressure plate needs replaced.
after the clutch master cylinder has been replaced.
At least the slave cylinder. The clutch master cylinder can be replaced at any time.
If the clutch stays on the floor after you push in the clutch first check to see if you have clutch fluid in the reservoir, if you do then it could just be because the clutch needs bled. If that doesn't do it then maybe your slave cylinder needs bled or replaced. From what I have seen it is generally because the slave cylinder needs replaced. Not to confuse you but the things that make up your clutch system are the clutch master cylinder, the slave cylinder, and the clutch dampner. If it is because the clutch needs bled start with the clutch master cylinder then do the slave cylinder. If it is not because of lack of fluid then check up under the dash and see if the spring on the clutch pedal is attached. Hope that doesn't sound to confusing.
Check your clutch master cylinder and slave cylinder for leaks,if no leaks,then you need a new clutch kit.
Clutch repair for a 1992 Sierra will depend on the problem. Clutch systems consist of the clutch, pressure plate and a master and slave cylinder. These parts are not repairable, and the part that has failed will have to be replaced.
Does my 1995 Toyota Paseo have a clutch cable
If it ain't the clutch itself then its prob. your slave or master cylinder.
The clutch and brake`s share the same resovoir the clutch master cylinder is attached to the top of clutch pedal and the clutch slave cylinder is inside the gearbox bell housing.