answersLogoWhite

0


Top Answer
User Avatar
Wiki User
Answered 2007-02-26 13:26:02

light should go off . if that was the problem, and is now fixed, disconnect the battery for 5 minutes,then reconnect battery this will reset the computer and remove the signal from the warning light if that doesnt work, there is a different problem apart from crankshaft sensor

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

Do you have a picture of location of crankshaft position sensor for 1992 Chevy Cavalier 2.2L ohv engine?

Do you have a picture of location of crankshaft position sensor for 1992 Chevy Cavalier 2.2L ohv engine?


Can a engine out of a cavalier fit in a s10?

I replaced my 1995 S10 2.2 engine with a 2.2 cavalier engine and it worked fine.


What could be wrong if a 1996 Buick LeSabre starts and drives then will not start again?

I had the same problem with a 1992 Park Avenue with the 3800 engine. I first replaced the electronic ignition but that did not fix the problem. I then replaced the crankshaft heat sensor. That fixed my problem.


Where is crankshaft sensor on a 1992 Chevy Cavalier?

its located at the rear of the engine (center) attached to the block


Engine code PO335 98 Chevrolet Cavalier?

Crankshaft position sensor circuit malfunction.


Where is the crankshaft sensor on a Chevy Cavalier 3.1?

Back side of the engine near where the transmission mounts to the engine. You have to jack up the car and crawl under it to see it. There are two sensors there.....the crankshaft sensor and the knock sensor.


Where is the crank sensor on a 1996 cavalier?

The crankshaft sensor is mounted to either the front side or the back side of the engine block depending on engine type


Where is the crankshaft sensor in a 1992 Chevy Cavalier?

Its on the firewall side of engine between transmission and engine just below the ignition coil packs one of the wire connectors from ignition module go to crankshaft position sensor


When do you replace the timing chain on a Chevy Cavalier?

Timing chains are designed to last the life of the engine and are replaced when the engine is rebuilt.


Why does the engine light keep coming on for the crankshaft sensor when it was replaced?

Faulty sensor get it replaced if not check to make sure wire isn't shorting out


Maxima engine cranks but no start?

the problem seems to be crankshaft or camshaft position sensor.


Where is the crank shaft on Chevy Cavalier?

Inside the lower part of the engine. The pistons are connected to the crankshaft by way of rods. Here is a rough diagram.


Where is the crankshaft position sensor on a Chevy Cavalier 2.2 l SFI?

AnswerThe crankshaft position sensor should be located on a small metal bracket very close to the harmonic balancer which is attached to the end of the crankshaft. If you are having trouble locating the harmonic balancer, it is the lowest pulley on the passenger side of the engine, in the centerline of the engine.


How do you retrieve the check engine light on a 1990 cavalier?

The check engine light cannot be retrieved on a 1990 Cavalier unless a problem develops with the engine. The engine can be checked for errors, though, by using a tester that is plugged into the vehicle's computer.


Where is the crank shaft position sensor on a 2.2 liter 1993 Cavalier?

The crankshaft position sensor is located on the rear of the engine. It is mounted just above the oil pan on the engine block.


Where is the crankshaft position sensor located on a 95 1500 Chevrolet?

That year did not have a CRANKSHAFT SENSOR.Need more info. to help you with your problem. Engine size and what your problem is. You will need to ask your question again with that infomation. THANK YOU.


Why the check engine light stay on 1998 Chevrolet Cavalier?

Have vehicle scanned to determine the problem


Why is the check engine light on in your cavalier?

A problem with the emission system. Need to have trouble codes checked.


When will you change timing chain for 1997 Chevrolet Cavalier?

The timing chain should last the life of the engine and not maintenance is normally required. It is replaced when the engine is rebuilt.


The engine light came on after you had the timing belt replaced Is this normal?

No problem


Check engine light on no signs of leaks or engine noises 2002 cavalier?

Usually an indication of a problem within the emission control system Have the vehicle scanned to determine the problem


Where is the Crank Position Sensor on a 1995 Chevy Cavalier and what does it look like?

Hey Jeff== It depends on which engine you have but I imagine it is on the module and senses notches on the crankshaft. GoodluckJoe


Where does the crankshaft sensor go in a 1998 Chevy cavalier?

Just behind the vibration dampner/main pulley on the front (passenger side) of the engine towards the top.


Where is the crankshaft located on the 2001 Chrysler sebring convertible limited located?

The crankshaft is the largest part in the bottom of the engine.The crankshaft is the largest part in the bottom of the engine.


Is the engine in the 1997 Chevy Cavalier the same as a 2003 Chevy Cavalier and can you put a 2003 engine in a 1997 Chevy Cavalier?

Well yes and no. Both have a 2.2 four cylinder if I'm not mistaken, but I don't think the earlier Cavalier's have the EcoTec motor. And you should be able to get the engine from the '03 into the '97 with no problem.