Scooters and Mini-Bikes

If your riding a scooter then you cut it off and it takes along time to crank again what is wrong?


Top Answer
User Avatar
Wiki User
2011-09-12 22:16:34
2011-09-12 22:16:34

It's probably flooded, meaning that there is too much fuel in the cylinder and it won't start until the fuel level drops a little. It can be carburetor problems or it could just be the way the engine was engineered. If there is a fuel shut-off valve, turn it off just before you shut off the engine, maybe 30 seconds or so. That should stop any flooding problem. Then turn the fuel back on just before you try to start it. Of course, this explanation only works for carburated engines but then I haven't heard of many injected scooters.

Answerits the spark or the engine is flooded do what the other person said or take out the spark plug pull the cord 3 or 4 times then put it back in and it should start back up

Related Questions

Depends on what you compare it to. It's one of the nicer Shimano lines, so for most riding it'll be quite stiff. But it's not as stiff as a dedicated DH/Am crank.

crank sensor in 2000 dodge neon fails. car starts to stall while operating. idols with no problem, when in operation starts to stall again and again until will not start again.

crank tool is in clips along the top of the frame in front of the radiator,under the hood

Mine is built into the ignition switch. After you crank it turn the key back to the left slightly.

100 Cubic inch about 85 (at crank) 106 Cubic inch 97(at crank once again) HD 96" about 67...

Link broken...

It really depends on your height. If your legs are longer, you should use that to your advantage and use the leverage of a longer crank. If you use a longer crank and don't have long legs, you can feel like you're riding a hear or two higher than you actually are, so make sure you don't get cranks that are too long!

Along with the Mech Crank, it completes the Walking Mech that is in the garage next to Sully's. To get the Crank, you have to go through the Living Quarters to reach the high vine at upper left.

6.0 powerstroke had crank case sensor replaced by a dealership. 24hrs of runtime and engine refuses to start again. what happened to owning a reliable diesel??

your engine will stall. When you try to restart the engine, it will stutter and stall again.

The crank shaft sensor is located on the bottom portion of the timing cover to the left of the crank pulley. Look for two wire harnesses and remove them along with the bolt.

The Ford F150 cranks and immediately stalls and shuts off. It will crank again, but it shuts off. The guages move back and forth also

If you are a good welder, make a piece to attach to the crank screw that would fit a "T" shape drill piece, then you can use an electric drill with the T piece, to start it.

Crank means to like crank ahandle.

The Rotten Tomatoes Show - 2009 17 Again State of Play Crank High Voltage 1-8 was released on: USA: 23 April 2009

Usually pretty common to have the replace the crank sensor or crank angle sensor. Before you do replace the camshaft sensor check that your timing is right on because this is the issue with about 75% of vehicles.

look along top of grill under hood in front of radiator

No, it will crank, but it will not start.

Go left along the vine and pick up the Mech Crank. Along with the Mech Motor you recovered from the Production Zone, use it to finish building the Mech walker.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.