If your signal lights and hazard lights are not working but you've replaced the fuses and bulbs what should you do next?
check the relay and switches if you dont know where they are look at owners manual or a haynes repair manual they help a lot on some stuff
I replaced the battery in my 1999 Subaru Legacy and the hazard lights come on even though the button is not pushed in I read on another question here what you should do but it's not working?
Why does a 1994 Buick LeSabre's turn signal sporatically flash when signaling to turn but work fine for hazard lights?
Ya think it might have something to do with warning about a hazard on the roadside? lol no really! actually they are what you put on to warn other drivers that YOU are a hazard on the roadside due to an accident or breakdown or stationary queueing traffic or any other danger, ie a hazard. In the UK, hazard lights should be used on single carriageway roads to warn other drivers that your vehicle is…
Hazard lights should only be used when your car is stopped or coming to a stop. Using them while you are actually still driving can be dangerous. Other drivers will be unable to tell if you are going to change lanes or get off the road because your turn signals or 'blinkers' will not work when your hazard lights are on.
the relay is behind the hazard light button in the center of the dash. you can hear the clicks of both the hazard lights and the signal lights coming out of that area. to change out the relay, take out the radio, and you should have a pretty easy access to the relay switch right above the radio unit. if you need precise instructions on how to remove the radio, do a quick research and…
Answer the brake light switch down at the brake pedal is most likely bad . Answer First, use a test light to check to see if the bulbs are getting power. If not, check the stop light switch. This is the switch connected to the brake pedal. When the brake pedal is pushed, this switch closes the circut and causes the brake lights to come on. Answer The brake lights are wired through the hazard…
The backup lights on your Jeep grand Cherokee limited 1995 are not working is there a dedicated fuse for them you have replaced the bulbs?
Your Volvo s40 has a dodgy hazard light switch When you turn it on no hazards In addition the blowers do not work Not sure if the problems are linked or not?
Where can you find the wiring diagrams for the fuse block the hazard lights and the horn for a 1981 Chevy Silverado 2 wheel drive 4 barrel 350?
go to your local library. They should have a repair manaual in the referece section. the hazard light fuse, should be in the top left corner of the fuse panel, its an odd shape fuse, it has L shape connectors and its round, sorry I'm not that techincal but i had this truck and i remember my hazards stopped working.
Who is at fault if you rear ended someone on the freeway who ran out of gas and is parked without the emergency hazard lights on?
Yes! Pilots are very careful about their night vision, and you -will- upset them if you put your headlights in their eyes. This is not to say that you should turn all your lights off though. You should have your parking lights on, as well as turning on your four-way blinkers (hazard lights) whenever driving on the airport ramp.