at the bottom of the antenna
how do remove the tailgate's window motor on a toyota 4runner 1997 ?
I have a 98 4runner limited and It has a power antenna, I recently replaced the mast for it and it's pretty easy to replace the antenna it self. not sure about the euro ,but I know that it's pretty easy to take off the motor (if you can get under the panel) and just replace it with a normal antenna
how do you replace a antenna motor for a 2000 Toyota landcruiser
No. If your wheel well has trim, you must remove that. Then remove the bolts that mount the fenderwell to the fender (this is not easy). This allows the fenderwell to be pulled back giving you clear access to the power antenna motor. Note that if the antenna is broken or doesn't go up and down anymore, you may be able to fix it by purchasing just a replacement antenna from Toyota. Typically the toothed cable breaks and all that is required is to remove the motor, disassemble the spool holder ( to remove the broken cable) and then install a new antenna.
it mounted on the throttle body
dextron II
I heard you have to take half the motor apart to get to them.
yes, it should fit. you may have to adjust how it mounts thought if the 4 runner was originally a v6.
I have a '94 4Runner that needed a new mast so I went to http://www.antennamastsrus.com/ and ordered a new one for about $30. The instructions were good and the fix was easy. Although, shortly after install my motor stopped working altogether. I am positive that the new mast didn't cause the problem, I think it needs a new fuse or relay. Hope this helps.
remove 7 of the 11 screws retaining the wheel well plastic in place (from the left side looking at the wheel) under the fender and push back a little bit the plastic and you will see the power antenna held in place by one screw to the body, don't pull out to far the antenna cable is still hooked to the radio. i know it can be done because I've done it, no problem.
kind of a touchy motor, if in tip top shape and a 5spd manual. get up 23mpg with the 3.0v6.