Recommended Standard 232
Recommended Standard Recommended Standard
RS422 and RS485 and the now popular USB
RS-232 is a standard built a longer while ago, and its specifications dictate a maximum voltage of +-25V. HIGH signal levels at +-5V, +-12V and +-15V are not uncommon. The range of operation is from -25V to +25V. Also, RS-232 standard notes that levels between -3V and +3V are illegal (as in, they are assumed not to exist, nor carry any information). On the other hand, TTL stands for Transistor-Transistor Logic, and the maximum rating for that is 5V. HIGH signal levels are at any point above 3.5V. The range of operation is between 0V and 5V. If one were to connect these with no conversion, the TTL device would probably be burned. Even if it would withstand, the designs are sufficiently different for them not to communicate properly. Thus, the need to 'bridge the gap' between the two.
flip-flop is a one bit memory device which stores the last output in memory. the output of flip-flop is based on the present input and past output. RS stands for reset-set flip-flop means that for particular value it sets and resets automatically based on inputs.
== ==
RS 7000/- per month for Electrical engineeringHostel dues Rs 5000/- per monthHostel mess Rs 90/- per day.For more information visit www.seecs.nust.edu.pk
RS232 means "Recommended standard no. 232", EIA standard for serial communication Thirumalesha.....
Its not, it just happens to be convenient. Other standards for UART communication include RS-422, RS-423, RS-481, and various others.
RS232 is a communications protocol for electronic devices to exchange information
RS-232 serial ports are far slower than USB ports. With very few exceptions, devices that use USB ports would be impractical to use on a serial port.
It stands for "Rally Sport".
rs232
It stands for Rupees.
rs232 isfaster than rs449
Whwn an IC is connected to a PC, then the voltage levels of these two should be synchronized. For this purpose, the TTL voltage level is converted to RS 232 level. RS 232 is the interface between a PC and an IC.
Depends what you mean by a serial cable - Fibre, Ethernet, RS232, RS485, RS422, USB, HDMI, SMPTE292 are all examples of serial communications media. RS232 max length 50 ft Ethernet max length 100 m
racing
RS stands for right stick. You push down the right analogue stick.