that keeps the dome lights on
Turn the lights on then disconnect the battery. This well keep the lights in the up position.
You disconnect your battery and then reconnect your battery again.
there is no button of switch you have to disconnect the negative battery terminal
Just disconnect a battery cable for a couple of minutes.
Disconnect the negative terminal to the battery and reattach - that resets the monitor lights.
As long as it does not obscure your lights or license plate you can drive with your tailgate down.
To replace dash lights on a Mazda B 3000 first disconnect the battery and remove the dashboard. Unplug the cluster wiring and carefully remove the display. Replace the lights.
What will happen is the car will not start nor will the electrical lights, radio ect. Unless your doing electrical work on the car don't dissconect the battery
On a 1998, you can kill the running lights by pulling the the 15 daylight running light fuse in the engine comparement fuse box. Manual says to disconnect the battery before openning this comparment.
You can use a code error reader (diagnostic tool) to reset service lights. Or you can disconnect the battery for 5 minutes it will do the job. If it didn't work, disconnect the battery for longer. PS. Don't forget to connect the battery back before you check the codes.
Replace the headlight switch that turns on the lights and parking lights, it's a whole unit that has the slider dimmer switch in it. Be sure to disconnect the negative battery cable first. Cheap at a salvage yard.
just had this problem with my 2002 durango, the mechanic ran it on the computer and nothing showed up so he disconnected the battery and then reconnected it and everything works now. The headlights, locks, panel lights, interior lights, locks, rear wipers all run through the body assembly moduale. Hope this helps you.
drop the tailgatethen remove screw holding lights in bed
Disconnect battery and wait about 3 minutes then reconnect and any error lights should be reset
disconnect the battery with the lights on and then press the horn for 5 seconds. This will erase the codes in the chip. Then reconnect the battery and the service light should be off.
lower the tailgate, remove the 2 screws on the side when you lower the tailgate, pull assembly out and replace
there is a relay under the hood that should disconnect the daytime running lights
pull down the tailgate and there will be two screaws or nuts on the inside of the tailgate where the light means the tailgate remove them and wigle the light and should come out the bulbs are on the back of the light
4x4 dash lights on a Dodge Durango don't work
command start malfunction, disconnect, problem solved.
After repairs are made. disconnect the battery cables, wait a few seconds and reconnect, that usually clears the codes, dash lights.......
Gen 1 or 2? With the drivers side you will have to remove the battery and then the nuts to the lights, disconnect the wiring and remove.
Under the glove box is a blue connector, disconnect it and disconnect the battery. After 30 seconds reconnect the battery and it should work. Leave the blue connector open for the lights to come on with the doors.