0
Generally, this means that a bulb is burned out, or that your flasher has died.
If you only experience the problem on one side, in other words, left signal only, or right signal only, you can pretty much count on it being a bulb. If it's on both sides, it's probably the flasher.
FriPilot
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Why is your 4x4 light blinking in your 2011 dodge ram outdoorsman truck?
That is an indication of a shift that has not completed. If it never stops blinking, you will need to take it in for service.That is an indication of a shift that has not completed. If it never stops blinking, you will need to take it in for service.
How do you fix a turn signal that stays lit but doesn't blink when lights are on?
Just replace the bulb. They stop blinking when the bulb goes bad. Usually if a bulb goes bad it will blink rapidly. If it stops blinking entirely or blinks only sometimes your flashing relay may have went out. It's a small box under the steering column usually.
2003 that the brake indicator and ABS indicator light come on and the speed odometer stops working What causes this?
vss sensor
Why would the right turn signal of a 93 Dodge Shadow start blinking and then the frequency of blinking is reduced and sometimes stops?
Change the flasher unit, change bulbs, bad ground, short in the wiring. i found in mine it was a bad ground at the pig tail what the bulb goes into. I had the same problems with both tail lights and back up lights. It was the ground on the sockets on all of the sockets. I just soldiered the ground wire to the side of the metal socket on all of them. It worked fine.
How is the blinking of an eye serve a usefull purpose for the body?
yes it stops moisture from the eyes escaping on cold days
Why does monitor light keeps on blinking for seconds after switching off?
The monitor light keeps on blinking for some time after switching off to indicate immediate loss of input signal. When the computer is switched on, the LED stops blinking and changes to green, indicating good signal reception.
Why is my television blinking on and off?
You might be sitting on your remote, pressing the Menu button, or there may be some infrared interference in the room. Try covering the IR sensor on the TV with your hand (if you can find the sensor) and see if it stops blinking.
Your speedo stops working every now and then and now the engine cuts out at the lights and the spedo stops?
You may have a bad ground
When driving lights go out and the car stops?
Easy! A tree or large boulder.
When a school bus with its red lights flashing is stopped ahead on your side of the what must you do?
Stop until the red lights stops flashing
What is the blinking red light next to the ford focus hazard switch?
From what ive read it is the passive security system, it reads a chip in the key once inserted and stops blinking. in other words the car wont start without the chipped ford key
What are the RCA satellite receiver codes for a Sharp Aquos ga600jsa remote control?
44 or 45 Press function until the LED for your device lights up. After the LED for your device lights up, press function and display at the same time to enter the code registration mode. The LED will start to blink. Press 0-9 to enter the manufacturer's code(preset mode is finished once the LED stops blinking). After the registration code has been entered, the LED will stop blinking then turn off after 1 second.(if you perform an incorrect operation, the LED will blink quickly and then turn off.)
