recover the r-134, remove the driver's side panel inside the rear hatch. Remove the rear expansion valve flush any debris out of the a/c lines and install a new rear expansion valve. Add the appropriat amt of oil back into the system. If you don't know, after flushing about 3 or 4 oz. Recharge the system with 3lb 8oz r-134. Run the a/c, look for leaks, Re-install the panel
first replace the tires of the aztek. then take a reciprocating saw, and cut the car in half.
well some scientist guy who had no life and decided to give names to a bunch of random gasses and metals and things like that
cadillac catera replace valve cover gasket 1997
NO. The transmission in that truck is electronic. They STOPED using a modulator valve back in the late 80s.
There are many components in HVAC and all of them have various types. For example: (01) Compression equipment: Compressor: Reciprocationg, Rotory, Screw, Centrifugal etc. In absorption system the compressing system itself is different. (02) Expansion device: Thermostatic Expansion valve, High side or low side float valve, caplliiery tubes, flutronic valves etc. and so on. The question shall be specific to get the answer
On a 2001 Ford Explorer Sport Trac : I believe the PCV valve is on the REAR of the drivers side engine valve cover ( between the valve cover and the firewall )
You mean the egr valve? Rios have precise timing with lower compression no need for an egr vale.
On the 4 cylinder engine - it is on the top/back of the valve cover with a hose attaching it to the intake manifold.
It is under rear in back of xterra under the spare tire next to evap can.
The NHL announced in 1997 that it had awarded an expansion franchise to Minnesota that would begin play in the 2000-01 season.
Begin by removing the valve cover retaining bolts. Peel the old gasket off and clean the surface. Put the new valve cover gasket on. Replace the valve covers to their original position.
Just behind the throttlebody. on the top of the intake manifold.
yes . install a rom
were is the tfp valve position switch location on a 2001 chevy blazer 4.3 lt modle
I have an 01 Chevy 5.3 single cab short bed 4x4. The PCV valve is on the back of the left valve cover.
IT DOSEN,T HAVE ONE
,018" both intake and exhaust.
if it has a connector it will be behind the license plate or you have to install one
The EGR valve for that 01 S10 2.2 L engine would be found on the top rear of the engine.
http://www.ehow.com/how_4811888_fix-egr-valve-ford-focus.html
The standard one for anything below 200 Kw's.
Take the valve cover off and the plugs will be right under it
The 2001 Ford E GR valve position sensor is attached to the firewall, in the engine compartment. The sensor will be on the drivers side of the engine compartment.
yes, and no. they can fit if you keep the chair rails from the 01 and install them on the 96 seats. the rails from a 96 don't match up with the 01.