answersLogoWhite

0


Best Answer

== == It depends what car and engine it was done in. If it was a D8 caterpiller that would have been a bargain. If it was in a Geo that probably is too much.

User Avatar

Wiki User

โˆ™ 2009-04-06 06:52:50
This answer is:
User Avatar
Study guides

Where I can purchase purchase HID Fargo ID card in Dubai

โžก๏ธ
See all cards
โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…
No Reviews

Add your answer:

Earn +20 pts
Q: Is a 500 dollar charge to replace the clutch master and slave cylinder reasonable?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the slave cylinder on a 1995 dodge neon clutch?

How do you replace a slave cylinder on a 1995 dodge neon clutch


How do you replace the clutch slave cylinder on a 1989 Jeep Wrangler?

How do you replace the clutch slave cylinder on a 1989 jeep wrangler


Should you replace your clutch master cylinder when replacing clutch?

At least the slave cylinder. The clutch master cylinder can be replaced at any time.


How do you adjust the clutch on an 89 Chevy 2500?

You can't, there is no adjustment. Time to replace clutch, slave cylinder or clutch master cylinder. 1 of the 3.


What if your clutch on your 85 Toyota corolla goes to the floor and is hard to shift?

There are two normal causes. The clutch is worn out or there is a leak in the hydraulic clutch slave or master cylinder. To check the clutch, press the clutch slave cylinder down. If the clutch slave cylinder bellows compresses down to the slave cylinder, the clutch is worn out. Check the clutch master cylinder fluid level. if this is low, then the clutch cylinder need to be checked. To check for a hydraulic leak in the clutch slave cylinder, remove the cylinder's bellows and check for any fluid. If fluid is present, rebuild or replace the cylinder and bleed the system. To check the clutch master cylinder, check the back the of clutch master cylinder for leaks. If fluid is present, replace or rebuild clutch master cylinder and bleed the system. In my experience, hydraulic leaks occur at the clutch slave cylinder.


What is a reasonable estimate to replace a clutch in an 1998 Audi a4?

£200.00


How do you replace the clutch slave cylinder on a 1997 Pontiac Sunfire?

you have to remove the tranny and clutch! 4-6 hours depending on who and where you get it done and the tools they have most people charge about $70/$80/hr


How do you tell if the clutch master cylinder is gone out on a 87 king-cab Nissan truck?

first check your clutch slave cylinder for leaks, if its leaking ,replace and bleed system,if its not leaking,bleed system ,dont forget to bleed clutch damperand if its still not right, then replace clutch master cylinder.


Leak in the cab of your 1991 Ford Ranger coming from the clutch What should you doshould you replace the entire clutch or is it just the line?

Replace clutch master cylinder and bleed system,also check your slave cylinder for leaks.its bolted to your transmission,the clutch cable is connected to it.


What steps do you take to remove and replace the master clutch cylinder of a 1992 Ford Ranger?

If you need to replace the slave cylinder it is located in the bell housing and the trans has to be removed. The clutch master cylinder is located on the firewall on the drivers side


How do you determine whether to replace the clutch system or the slave cylinder on a 2002 Ford Ranger 4 cylinder?

have someone mash the clutch while you are under the truck looking at the cylinder to see if its moving, if no movement undo the line and hold your thumb over it and have someone mash the clutch to see if brake fluid squirts out, if no fluid squirts out, replace the clutch master cylinder


If i replace slave cylinder will that make my clutch disengage and engage correctly?

if i replace slave cylinder in 1994 Honda civic ex will this make my clutch disengage and engage correctlyanswerchange master cylinder and slave properly then bleed the system properly.

People also asked