answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2006-08-10 15:01:17

No! The ECM is the Electronic Control Module (Computer), sometimes called ECU, Electronic Control Unit. The ignition switch is just that, the switch that controls the engine ignition, the power to the starter, starting and shutting the engine off, and power to the accessories.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


Remove the retaining ring from the top of your 1990 Lexus ignition switch. The ignition switch will slide out. Remove the wiring harness.


Begin by removing the retaining ring at the top of your 1990 Pontiac Bonneville ignition switch. The ignition switch will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.


how do you remove the ignition switch on a 1990 chevy half ton pick-up?


The ignition lock is where you put the key. The ignition switch is located on the top of the steering column directly above the brake pedal.



Bad ignition switch or wrong key.Just replace with new switch about $10.00 NAPA


It doesn't have one, the fuel system is relay controlled by a computer.


you have to go under the dash and take out the steering column. and the ignition switch should have a wire going down to the bottom of the column coming from the ignition lock.


If your high beams still work it is the dimmer switch.


NO, there is no coalition between the ignition switch and the transmission. The ignition switch does 2 things. Turns on power to the electrical system for the engine and supplies power to the starter during start-up.


i need help son started drilling out ignition switch cause he lost his keys how do you do it ? 1990 lincolon town car helpjust keeep on drilliln till it pops



might be something with starter/solenoid assembly or the crank wire circuit coming from the ignition switch.


Your brake light ignition switch should be replaced. It works your brake lights and ignition switch, so you do need it. It only costs about $7 dollars.


How do you change the steering shaft in a 1990 Jeep Wrangler?


Your fuse could be blown, or the brake light switch is improperly adjusted.


Ignition relay is probably shot. It is in the power distribution block in the motor comprtment.


No. 2005 is link and coil. 1990 is leaf spring.


i have a 2003 Pontiac grand am, no start, does not even turn over. could it be the ignition switch?



The amount of oil needed for a 1990 Jeep Wrangler is 6 quarts. The Jeep Wrangler uses 10W 30 oil.


I shouldn't, 1990 is a YJ and the 97 is a TJ.


Replacing the ignition switch is very simple. When you purchase the new switch it will give you photos adn simple instruction to follow. Youy will need some toolls. Good luck and God bless you. lemon Pro


It is very possibly the ignition switch but there are certainly other possibilities as well. In any case, you'll need to learn some electrical diagnostic skills. The ignition switch appears faulty.


It doesn't have one, it has a switch on the clutch pedal. It also has an interlock switch on the dash, turn the ignition switch on and press the interlock switch and it will bypass the clutch switch.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.