answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2009-11-30 19:37:11

That is not a very clear question. Are you asking if the materials left in a propane tank could be toxic if you use the tank for water? If so, then the answer is yes, but you are not going to be having a lot of ethyl mercaptan. An old propane tank can contain a significant amount of hydrocarbons, usually in the gasoline and diesel boiling point range.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


When produced propane and butane is odorless and colorless. Ethyl mercaptan is the odorant added to propane and butane in the processing and refining process to provide a detectable odor. Under certain conditions the odorant in propane may oxidize and lose its destictive odor. This odor fade can occur in new steel containers when first placed into service and in older steel containers that have been left open to the atmosphere. Air, water, or rust in a propane tank or cylinder can also reduce propane odor concentration. Ethyl mercaptan is toxic although the amount added to propane is non-threatening.


"Historically, first gas odorization was carried out in Germany in 1880's by Von Quaglio who used ethyl mercaptan for detecting gas leakages of blue water gas."


On combustion: C2H6S + 6O2 ---> 2CO2 + 3H2O + SO2 All of the products of the reaction (carbon dioxide, water, sulphur dioxide) are gases


water is more dense than ethyl acetate , so water remains on bottom and ethyl acetate on top when both mixed.


Solubility of ethyl acetate (ethyl ethanoate) in water is 8.3 g/100 mL at 20 °C.



no ethyl cellulose is insoluble in water, propylene glycol and glycerin



The miscibility is low: the solubility of ethyl acetate in water is 83 g/L.


Ethyl acetate is miscible with cyclohexane and ethanol; not very soluble in water.


Polyvinyl acetate is soluble in a number of organic solvents. Solubility of polyvinyl acetate is directly related to the volatility of the solvent; the more volatile the solvent, the more soluble the polyvinyl acetate. Some of the most common solvents, ranked in order from the most volatile to the least, are listed below.1. diethyl ether (very volatile, water miscible) 2. acetone (best solvent that is commonly used) 3. benzene (very toxic) 4. ethylene dichloride (very toxic, non-water miscible) 5. methanol (toxic, cumulative poison) 6. methyl ethyl ketone (MEK) (toxic) 7. ethanol (denatured alcohols may be toxic) 8. toluene (slightly toxic) 9. xylene (slightly toxic) 10. amyl acetate (slightly water miscible) 11.ethyl acetate


Yes, ethyl alcohol is a polar compound, that is why it dissolves in water.


it slightly soluble in water.



It is an example of esterification. It produces ethyl butanoate and water. It is an example of esterification. It produces ethyl butanoate and water.


Ethyl alcohol has a specific gravity of 0.78, so it will float on water (1). Olive oil is 0.703 so it will float on ethyl alcohol.



Ethanol is very miscible with water.


The mixture water-ethanol is homogeneous.



on basis of solubility in water. ethyl acetate.


water is not a byproduct of the process it is ethyl alcohol



Amphetamine is "Soluble in water" according to the MSDS sheet Ethyl Alcohol is easily soluble in cold water, hot water and soluble in methanol, diethyl ether, acetone.


Methanol is miscible in water but Ethyl Acetate is immiscible in water. -- The above answer is correct if asking if each solvent is miscible in water. If you are asking if they are miscible together then the answer is yes, they will mix.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.