0
No, frame delimiting is a primary responsibility of the Logical Link Control sublayer of the Data Link Layer..
Data link layer exists of 2 sublayers; Media Acces control Sublayer (MAC) & Logical Link Control sublayer (LLC)
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What are two primary responsibilities of the Ethernet MAC sublayer Choose two?
What are two primary responsibilities of the Ethernet MAC sublayer? (Choose two.)
What are two primary responsibilities of the Ethernet MAC sublayer?
MAC provides physical addressing. The BIA (Burn In Address) which is stored in RAM when the computer boots up is added to each frame that is created as the source mac address. But to answer your question, the MAC layer does the following: Data Encapsulation and Media Access Control.
Where do the MAC sublayers fit into the OSI model?
MAC sublayer is located at Data link layer.
What Data Link sublayer manages flow control?
LLC (Logical Link Control) sublayer - The LLC provides a common interface and supplies reliability andflow control services.Hope this helps,A. York
Which sublayer of the data link layer prepares a signal to be transmitted at the physical layer?
MAC
What is a private MAC address?
A MAC address is unique to your ethernet card. MAC addresses are used within an Ethernet network to uniquely identify the source and destination of Ethernet frames. ARP (Address Resolution Protocol) is used on IP networks to map IP addresses to MAC addresses within an Ethernet network.
Difference between media access control and LLC?
* MAC sublayer(802.3): defines how to transmit data on physical layer * LLC sublayer(802.2): responsible for identifying different protocol logically & encapsulate them.
Which of the OSI layers translates the MAC address into a physical address?
The MAC sublayer is part of Layer 2 - Data Link Layer - but it is more correct to say that the MAC address is the physical address.
Difference between IEEE 802.3 AND 802.4?
IEEE 802.3 is the standard for Ethernet LAN. It is a collection of IEEE standards for physical layer and Data link layer's MAC sublayer. According to these standards, the Ethernet LAN card works. IEEE 802.4 is a Token Bus standard which was standardised by IEEE. It grants the Bus physical topology to use token messages to access physical layer.
What is Mac protocol?
mac protocols are medium access protocol. mac is sublayer of data link layer in osi model.it provides addressing and medium access mechanism
What are the Ethernet frame parts?
what are the ethernet frame parts The source and destination MAC addresses
Can there be more than one Ethernet adaptors that have the same Ethernet MAC address?
One computer must have unique MAC addresses for each Ethernet adapter (ideally each Ethernet adapter in existence has a unique MAC address but there are some that allow manual setting of the MAC, so duplicates can exist.) If you have not changed anything from the factory settings then each network card will have a unique address!
