It will take an experience mechanic approximately 8 hours to replace the timing belt in your 1992 Chevy Corsica. The 1992 Chevy Corsica does not have each timing chain, it has a timing belt.
take the old one off, put a new one on.
The radiator drain on a 1992 Chevy Corsica is located on the bottom, left side of the radiator. It provides a quick and effective way to drain the radiator during maintenance.
how do you replace a CV joint on a 1992 Chevy pickup?
typically in the valve cover.
Usualy the tensioner or idler pulley is spring loaded and can be pulled backwards allowing enough slack for the belt to slip on easily On a 1992-1996 Beretta/Corsica, the upper engine mount needs to be removed in order to remove/replace the serpentine belt. Replace the belt, and reinstall the engine mount.
The 1992 Chevrolet Corsica ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
The switch is bad. Grease inside the switch has burned.
Put the new serpentine belt on to your 1992 Chevy Corsica pulleys. Push the tensioner pulley to the left to tighten the serpentine belt.
IN THE ALTERNATOR
Since the 92 Chevy Corsica is equipped with SRS (Saftey Restraint System), ie: Airbags, which is located in the steering wheel. In order to replace the turn signal switch you must remove the steering wheel. Therefore I would only highly advise you to take it to a dealer to have this done.
located in the fuel tank of a 1992 corsica ,it may be the same for your model if this is so you may need to drop the tank . I would notadvice you to take on this job unless you have to.
It is located on the drivers side of the car on the bottom of the radiator
on steering wheel colum,the turn switch works it
go to autozone or other auto supply store and ask for a "flasher" for your year make and model. i just hate this problem on my 94 corsica.
Passenger side top of engine, in front of the alternator.
I once replaced the Chevy Bowtie logo on the front of my 1992 Corsica with an old Batman night light. Might be worth your time to search for some.
It uses DEXTRON III automatic trans fluid.
how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder
Generally, getting access from under the hood ,you remove the 6 screws holding the motor in place, then remove the ground and hot wire and finally the vent tube. Reverse procedure.
It's inside the fuel tank. The tank must be removed. You should replace the inside tank filter as well. There is also an inline filter visible under the car outside the tank, change it too.