answersLogoWhite

0


Best Answer

its far easier to replace engine and gearbox as a one unit. that way you dont have any stuggeling to do. i all comes out from underneath the vehicle as one .

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Is it easier to replace engine and transmission together or apart in a 98 cavalier?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Do you need to remove the engine to replace the transmission in a 1990 Acura Integra?

No but to me it's just easier


Starting Chevrolet Cavalier grinding?

sounds like you have broken some teeth on the fly wheel gear.Hopefully it on the starter itself which is easier to replace.


How do you unbolt a motor from a transmission on a 97 cavalier z24?

On front wheel drive vehicles it is easier and quicker to remove the trans and engine as one unit. then you can separate them if you wish


How do you replace clutch for 1982 gl wagon?

it is easier just to pule the motor that to pule the transmission when you get it out the clutch is right there


How do you change the transmission shift switch on a 1998 Saturn SL2 with an automatic transmission?

The Neutral safety switch is located on the back of the automatic transmission. it is quite simple to replace. It is probably easier to replace from under the vehicle, but it is accessable from the top if your vehicle is not equipped with ABS.


Can a 94 Mercury Topaz transmission be replaced from under the car or do you have to take transmission and engine out together?

they both come out together through the top much easier it is possible but it is easyer to pull them both out.


Is it easiest to replace the engine on a 1992 Acura Vigor 2.5 automatic with or without removing the transmission at the same time?

You are better taking off the engine with the transmission together, I have a 93' Vigor and changed the transmission and it pretty hard, there many bolts that are hard to get; if you need to changed your engine, it will be much easier taking the transmission off while the engine is off the vehicle..


How do you get the piston part out of the back brake drum of a 2002 cavalier?

Just replace the whole wheel cylinder. It's just as cheap and easier than rebuilding them.


How do you replace the flywheel on a 1976 F100 with a manual transmission?

If the truck is a 4 wheel drive it would be easier to remove the engine to replace the flywheel. If the truck is a 2 wheel drive removing the transmission and bell housing is the way to go.


Is it needed to remove the transmission with the engine of a 2000 Chevy cavalier with a 2.2L motor?

If it's an automatic transmission it can stay in the car. Simply unbolt the torque converter from the flywheel and the trans from the engine. If it's a manual trans it's not that simple. You don't have enough room to slide the engine forward from the input shaft on the trans. It's easier to pull them both together.


How do you replace a shift fork in a 1996 F250 Can you replace it from the top or must the transmission be removed?

The fork replacement could depend on which manual transmission is in the truck. The top has to be removed from the transmission. If the floor center can be removed with enough room to get the top off then it can be done. With carpet and seat removal it is often easier to remove the transmission.


Where is the automatic transmission shift sensor on a 1996 Saturn SL1?

The Neutral safety switch is located on the back of the automatic transmission. it is quite simple to replace. It is probably easier to replace from under the vehicle, but it is accessable from the top if your vehicle is not equipped with ABS.