never, ever!!! it is very dangerous to leave a hot plate or even a cooking stove unattended
!!
Use a hot plate
a magnet or hot plate
There are a number of circumstances when a hot plate would be used. Cooking is one of these. Hot plates are also extensively used in chemistry laboratories.
* A hot plate should measure temperature because when you use it, it will boil because of the heat coming up. Since there is heat, it measures temperature.
on your plate
Did you mean use china vessels on hot plate?It need to be warm-up before use it.
Use a hot plate
a magnet or hot plate
There are a number of circumstances when a hot plate would be used. Cooking is one of these. Hot plates are also extensively used in chemistry laboratories.
You can read a guide about how to properly use an induction hot plate on this website: theinductionsite.com/how-induction-works.shtml. Always exercise caution!
You can use pot holders or oven mitts to avoid being burned when lifting a hot plate.
The THD Hot Plate is a power attenuator for a car stereo system. You can use the THD Hot Plate to keep a power source to your amps. The Hot Plate is used by serious car stereo enthusiasts.
No. A crock pot is what you use for slow cooking roast and such. A hot plate is essentially a portable stove burner.
When you want something heated not too hot.
* A hot plate should measure temperature because when you use it, it will boil because of the heat coming up. Since there is heat, it measures temperature.
It can be used for several reasons. Sometimes the plate is served very hot, and you can move the charger rather than burning yourself moving the plate. If the plate is very hot, there is a danger of it scorching the tablecloth. The charger prevents that, also.
3 plate mould is chosen when you want to use point gate on the plastic part but you dont want to use hot runner or hot runner cannot be used. It means that when you want to use point gate with cold runner, 3 plate mould will be used. The 3rd plate in 3 plate mould is similar to the monifold for hot runner, is for material flowing. The advantages to use 3 plate mould is the point gate and automatic dropping of material, low cost. The disadvantage is material waste because of sprue gate. For more details, pls contact sinomoud-13@hotmail.com