answersLogoWhite

0


Best Answer
Copy

I think you are talking about the air-crossover manifold not the heads. Never tried it but think this part should interchange

User Avatar

Wiki User

โˆ™ 2005-03-29 19:44:46
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: Is it possible to interchange cylinder heads on old one bolt air filter and new two bolt airfilter 5.7 Oldsmobile diesel engines?
Write your answer...
Submit

Related Questions

Can you interchange a cylinder Mitsubishi eclipse engine with a 4 cylinder Mitsubishi Galant transmission?

if its the 2.4 liter its the exact same motor so yes, this would be possible


Is it possible to interchange the cylinder on a 38 police special to a 357 cylinder?

In short, no. The pressure rating of the barrel of a .38 gun will not handle .357 pressures reliably. Even if you could somehow find a cylinder that would fit, it would eventually blow up in your face.


What is the possible solution to a mis-fire in the 7 cylinder on a 1998 Oldsmobile Aurora?

check for bent or burnt valve check for bent or burnt valve


Will a 1991 dodge Dakota interchange with a 1992?

It is possible.


How is it possible for a cylinder of helium to fill 700 balloons?

It is possible or a cylinder of helium to fill 700 balloons because the helium in the cylinder is compressed.


How do you get volume of cylinder with no height?

this is not possible


Will 2000 passat 1.8l interchange with 1999?

It is possible for a 2000 Passat 1.8L to interchange with a 1999 version. However, the interchanged numbers must match the older version it is being replaced with.


Will browning a 5 recoil spring interchange with Remington model 11?

Possible, but, have a gunsmith check it out.


Does a 1999 Ford Taurus with a 3.0 V6 interchange with a 2000 Ford Taurus?

It's possible to interchange from '96 to 2001 with some minor differences. From 2001 to '05 with a few more differences.


Is it return is possible in lpg to cylinder?

yes


Your 1988 Oldsmobile turns over but will not start what can it be?

POSSIBLE CRANKSHAFT POSITION SENSOR.


Is it possible to replace only one cylinder in a four cylinder 2005 Mitsubishi lancer?

No! A cylinder is a cylindrical hole in the engine block.


Is it possible to create a cone and a cylinder from a frustum?

No, it isn't.


Can a cylinder never have the same volume as a cuboid?

Given a cuboid it is always possible to have a cylinder with the same volume.


What is fuel economy on a 93 Oldsmobile Cutlass?

Around 27-29 highway is possible.


What is the height of a cylinder with an area of 10 square meters including the ends and a diameter of 75cm?

These dimensions are not possible for a cylinder.


What are the possible reasons for a 1994 F-250 with a 5.8 liter V8 to have extremely low gas mileage?

the gas lines may need to be cleaned. the airfilter may need to be replaced


How do you change master cylinder on 2003 Oldsmobile alero?

unplug electrical connector for the fluid level warning switch. remove as much fluid as possible from master cylinder, with a syringe or similar to suck out the fluid. take off the brake lines to the cylinder. pull lines away from cylinder, and cap the ends so you do not loose fluid from the lines. remove the nuts attaching master cylinder to firewall. pull the cylinder off of the studs to remove it. bench bleed the new cylinder before installing it. (that means to remove all air trapped in cylinder). fill up new cylinder with new fluid, and push on plunger of cylinder to release the air. do this until no more air bubbles are presant in cylinder. if no fluid is lost from the lines and all the air is out of the cylinder. there is no need to bleed all the brakes just bleed by remove lines at cylinder if needed. GOOD_DAY!


Is it possible that my security system causes my 2001 Oldsmobile intrigue to not start?

It IS possible. Tell us more-- does it crank over? Have you checked anything else?


Cylinder diameter 300mm and Height 3097mm May I know the Weight of this Cylinder?

It is impossible to determine the weight of the cylinder without knowing additional details. Such details include the material which the cylinder is made of, as well as any possible contents of the cylinder.


Can the transmission in a 1996 be put in a 1997 Ford Windstar?

This is very likely to be a possible interchange.See "Related Questions" below for more


Would it be possible to drop a 1.9 Liter Turbo diesel Volkswagen engine into a 2005 ford ranger 2.3 Liter 4-cylinder?

a little cut and weld, anythings possible ;)


Is it possible to put a 440 super commando engine into a 1970 Oldsmobile cutlass?

While anything is possible, such a transplant would be extremely cost-prohibitive and impractical.


Draw a cone cylinder and triangular prism WHAT DOES THIS LOOK LIKE drawn?

It is not possible to draw a cone cylinder and triangular prism in this platform.


Cylinder shaped organelle in animal cells?

No if it were possible you would have learned about it