not for very long without overheating. Replace as soon as possible
Resistor have a definite function in circuits and because every resistor disspates power, it is not included in the circuit without good reason. Some smoke detectors have electronic circuits in them, and these would have resistors, but it is not possible to be more specific.
There is many uses for the resistor in electronic circuits, like current limiting, voltage division, R/C oscillators and many more. Without the resistor electronics is not possible
No, I've attempted to do this, and the shoes would have to be very loose on your feet in order to get the sock off without ripping/tearing it. Sorry! :(
Not without major modification, no.
instead of tearing it just cut it with scissors.
No, not without major modification.
insulation in the wall
So that they can be born without tearing the mother to pieces.
Wheels from 1994-2004 Mustangs will interchange with the 1995 wheels without a problem.
There is no way to know without tearing the engine apart.
No. You will not get the tire on the rim without tearing it.
Yes a 429 would fit into a 1969-1970 ford mustang without no engine compartment mods
No, the Boos 429 will need mods for the engine to fit in the 1998 Mustang.
The power rating of a resistor determines how much power it can dissipate without being damaged. For example, a 1/4W resistor is designed to handle up to 1/4W continuously without being destroyed. When selecting a resistor to use in a circuit, use Ohm's law to calculate the power it will dissipate. For example, placing a 1kΩ resistor across a 12VDC signal will allow 12/1000 = 0.012A to flow thru the resistor. 0.012*12 = 0.144W will be dissipated. Thus, a 1/8W (0.125W) resistor would not be sufficient, and a 1/4W (0.25W) must be used.
The question is incomplete without the voltage across the resistor. For example: if V (Voltage across 500 ohm resistor) = 5 Volts, then, Current, I = 5/500 Ampere = 0.01 A.
How much power it can dissipate without being damaged.
To limit the amount of voltage through a circuit.
The wattage rating of a resistor just tells you how many volts can be across the resistor times the current flowing through the resistor. If there is a resistor in series with the LED then the higher the resistance, the lower the brightness. A low wattage rated resistor would effectively limit the maximum current that could flow without the resistor self-destructing so in that sense a low wattage rating would also limit maximum brightness.
A resistor determines the speed that electrical energy is spent, the power. Without it, the supply is spent immediately and cannot be stored.
It is not possible to get herpes without contact.