Yes! You compare the dewpoint and temperature lines on the Stuve Chart. The closer the lines are together, the more saturated the air is. Hope this helps!
When a solution has accepted as much solute as is possible at a given temperature, the solution is said to be saturated. Under certain conditions, saturated solutions can be concentrated to give supersaturated solutions. Supersaturated solutions are those which possess more of a solute than normally dissolves in a solvent at a given temperature.
When a compound become insoluble in a liquid at a given temperature and pressure a saturated solution is obtained; the limit of solubility is reached.
In that case, it would be good to know what you aregiven. It is possible that you don't have enough information.
Saturated air is air that is holding as much moisture as it can at a given temperature. Unsaturated air does not contain the full amount of moisture possible at a given temperature.
water table isobar
saturated solution
When a solution has accepted as much solute as is possible at a given temperature, the solution is said to be saturated. Under certain conditions, saturated solutions can be concentrated to give supersaturated solutions. Supersaturated solutions are those which possess more of a solute than normally dissolves in a solvent at a given temperature.
It is not possible to answer the question with the information given - particularly with the form in which it is given.
From the information given in the question, it's not possible to determine an answer.
It is not possible to find the nth term from the given information.
It is not possible to answer the question from the information given.
It is called a saturated solution. This is created by adding in solute until no more solute dissolves. Then the excess solute is filtered. This works much better for a saturated solution at room temperature, as when the solution hits the filter paper, some will come out because it is colder.
Using the information given in the question, it's not possible to know.
It is not possible to answer the question with the information that is given.
When you add items that can be dissolved, and it doesn't dissolve in the liquid, it means that it is saturated.
With the amount of information given in the question, it is not possible.
It might have been possible to answer the question if there was information about: what x iswhat B iswhat 4.0 is a measure ofwhat 58 is a measure of.But, given none of that information, the question is impossible. It might have been possible to answer the question if there was information about: what x iswhat B iswhat 4.0 is a measure ofwhat 58 is a measure of.But, given none of that information, the question is impossible. It might have been possible to answer the question if there was information about: what x iswhat B iswhat 4.0 is a measure ofwhat 58 is a measure of.But, given none of that information, the question is impossible. It might have been possible to answer the question if there was information about: what x iswhat B iswhat 4.0 is a measure ofwhat 58 is a measure of.But, given none of that information, the question is impossible.