Head Gaskets and Valve Covers
Chevy Camaro RS
Is it worth replacing a blown headgasket on a 98 Grand Voyager with 138K miles If I spend 1000 to replace the head gasket won't the lower part of the engine be weaker?
How do you replace the water pump on a 1994 Plymouth Voyager?
The process of replacing the water pump varies dependig upon the engine size Please post the engine size and will try to provide you with the needed steps ...
Asked in Thermostats, Plymouth Voyager
How do you replace the thermostat located on a 1998 Plymouth Voyager?
Follow the upper radiator hose from the radiator to the engine and there you will find a housing with the thermsstat inside. When replacing the thermostat make sure the spring goes toward the engine. ...
Asked in Dodge Caravan
Can you replace a 94 V6 3.0 dodge caravan engine with a 4 cylinder 2.4 Plymoth voyager engine?
You cannot replace a 94 V6 3.0 Dodge Caravan engine with a 4 cylinder 2.4 Plymouth Voyager engine. The reason is because the engine is too small. ...
Asked in Fuel and Engines, Chrysler Sebring
How much does it cost to replace the engine in a Chrysler Sebring?
The cost to replace the engine in your Chrysler Sebring will range between $2000 and $6000. Replacing with a used engine will be the cheapest and replacing with a brand-new engine will cost the most. ...
Where is the voltage regulator on a Chrysler voyager?
internal to the engine computer The voltage regulator on a 2000 Chrysler Voyager is located within the Powertrain Control Module. If you want to replace the voltage regulator, you have to replace the PCM. ...
Asked in Auto Parts and Repairs, Jeep Wrangler
How much does it cost to replace a head gasket on a 1993 jeep wrangle with 6 cylinder engine and is it possible the mechanic broke it when fixing the radiator and water pump?
not sure of the cost. I doubt the mechanic broke the headgasket. More than likely when the radiator and water pump went bad the engine overheated enough to ruin the headgasket. ...
Asked in Acura SLX, BMW 5-Series, Saturn S-Series
How much should it cost to replace the headgasket on a 96 Saturn SLI 1.7 L?
I was told by a mechanic I called that to replace the headgasket for a 95 sw1 will be around 800-1100 depending on how much machining is needed. SOHC engine is known for cracking heads. Reman head from Saturn is approx $300. If you need a head I/d say at least 1000 ...
Asked in Chrysler, Timing Belts and Chains
Does the Chrysler voyager 2.5 have timing belt or timing chain?
Belt on the 2.2 DOHC engine, replace at 120,000 miles. It is an interfernce engine. If the belt breaks, serious engine damage will occur. ...
If the timing belt breaks on a 2003 Chrysler PT Cruiser do you need to replace the engine?
The valves can bend. You would then be repairing or replacing the engine.
Asked in Cadillac DeVille
How much do it cost to replace a 97 Cadillac deville engine?
5 to 7k at the dealer. You can replace it yourself with a used engine but I would recomend doing a time cert job on the block before installing it and that is a lot of work. Besides headgasket failures these engines are very reliable and can go forever. ...
Should you replace condenser and points on a 6hp Briggs Stratton engine?
If they are bad, then yes. If not, then don't bother replacing them.
Asked in Catalytic Converters
Will a bad catalytic converter cause water to run out of the tailpipe?
No. Water is a normal byproduct of the combustion process. It can also be an indication of an internal engine issue such as a failed headgasket. No. Water is a normal byproduct of the combustion process. It can also be an indication of an internal engine issue such as a failed headgasket. ...
How do you change the headgasket on 1991 Acura Legend?
You dont wanna know man. takes 8 hours if you know what you're doin' better off getting a new engine before you change the head , you may have also a cracked block or at least a semi crack block if it had ran hot prior to you replacing the heads m and you change the heads, then somehing else goes wrong nad it takes about 8hours to replace the heads..bout the same as replacing an engine, im doing one right...
Asked in Saturn S-Series
How do you change a headgasket in a 1993 Saturn SL2 twin cam?
To replace the headgasket you'll need to remove the head and take it to a machine shop. A headgasket fails when the head warps, removing pressure from portions of the gasket. the new headgasket will not last if you don't have a machine shop shave the head to make it perfectly flat. Removing the head is a little involved; you need to remove the front cover/oil pump assembly (all in one) to remove the head. It's easier to just pull the engine. ...