It can be anything you like, although often it is time.
The place where two faces (planes) intersect is called an edge.
The fifth dimension is time travel; one step forward past the fourth dimension. So, it's just like building up energy and moving from one place to another. It would look just as it sounds. But, I think time travel is a stupid idea. It creates two alternate universes. One is the unchanged world where you didn't travel and one where you did, creating ANOTHER dimension.
If the pole is on level ground then you have the outline of a right angled triangle with an opposite side of 3 feet and an adjacent angle of 30 degrees. To find the length of the adjacent side (which in effect is the shadow of the pole) use the tangent ratio: tangent = opposite/adjacent which can be rearranged to: adjacent = opposite/tangent adjacent = 3/tangent 30o = 5.196152423 feet Therefore the shadow cast by the pole is 5.2 feet corrected to one decimal place.
opposite^2+adjacent^2=hypotenuse^2 ____________ X=/hypotenuse^2 One decimal place would be, for example. 22.7 cm
If you are in, or aware, of the tenth dimension, this means that you are able to place yourself in any realm of possibility (and impossibility) that you can imagine yourself in. Essentially, you can change the entirety of the world around you to the exact specfications you see fit. The Tenth Dimension is the sum of all possible universes that have the same initial conditions as ours, and the sum of all possible and impossible universes with different initial conditions as ours. Basically if you can interact or are in the tenth dimension... there is nothing that can't be done... anything can be done.
I think such a dimension would be a very boring place to live. I think I'd call that dimension {0}.
No it is not a place it is a planet!! not as we would describe it. Dimension would be closer.
It is usually referred to as the destination.
Chromosomes are copied.
Lines that define the parameters of a dimension.Dimension lines are thin lines terminating in arrowheads. Place dimension lines no closer than 3/8" from the object outline. Parallel dimension lines should be a minimum of 1/4" apart. You may place parallel dimension lines more than 1/4" apart so long as the spacing between dimension lines is uniform throughout the drawing. Dimension lines are generally broken in the center of the line to provide a space for the dimension figure. Dimension figures for parallel dimension lines are staggered. In some structural or architectural drawings, you may find dimension figures placed above the dimension line.
A liquid has adjacent molecules that are not locked into place.
You have to place on your existing chicken coop
It is called the Destination Area, and is where data is pasted after it has been copied or cut.
Concentration Gradient
weather
In a vacuum no matter exists.
Diffusion gradient