On the v6, yes.
The cylinder position sensor is located in the distributor.
It is inside the distributor. It is only serviced with the entire disributor.
The Camshaft sensor is located in the distributor.
Where is cam shaft position sensor on a 4.3 engine. Located?
located in the distributor
The crankshaft position sensor is located on the top of the transmission. It is located close to the bell housing.
It's located on the distributor. You don't have to remove the distributor to replace the sensor. Remove the air cleaner, disconnect the negative battery cable, remove the distributor cap, disconnect the camshaft position sensor wiring harness, remove the distributor rotor, lift the camshaft position sensor assembly from the distributor housing Camshaft Position Sensor. Installation, Install the camshaft position sensor into the distributor. Align the sensor into the notch on the distributor housing, connect the wiring harness, reinstall the rotor, reinstall the distributor cap. Tighten the mounting screws, reinstall the air cleaner.
The sensor in the distributor is the crankshaft position sensor.
It is in the distributor.
inside of distributor
Cam position is taken from the distributor on this vehicle, there is no separate cam sensor.
its located in the distributor at the back of the motor.