0
yes it is stored in CMOS
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the saved BIOS configuration data sotred?
BIOS configuration data is stored in CMOS memory. That is where all the basic hardware settings are kept. CMOS has traditionally been volatile memory, so a battery is required. Newer BIOSes often use NVRAM.
Where is the saved BIOS configuration data stored?
All the settings from the BIOS are stored in a chip which is located on the motherboard. That chip is called EEPROM (electrically erasable PROM).BIOS configuration setting is store in special memory called CMOS. Which is little powered by a battery. RAM is volatile so when computer turned off, all data lost.This can also happen with CMOS but due to this purpose it is powered by battery. It consumption of power is very low and it can store data for 1 year.CMOS stand for "Complementary Metal Oxides Semiconductor".
Do you need a cmos battery for your computer to boot?
Most new computers can automatically determine the correct settings needed for your hardware, and some even store configuration data in a non-volatile Flash chip. These computers effectively do not need a CMOS battery for anything except maintaining the correct time. Older computers, where you had to specify the parameters for the hard drive in the BIOS, need a CMOS battery. Otherwise, you would have to enter them in every time you booted the computer.
16-bit real mode program that queries the computer for time and date and surveys hardware?
This is the right answer:Ntdetect.comAfter the boot selection is made, Ntldr loads and executes this 16-bit real-mode program to query the computer for basic device and configuration information. This information includes the following:The time and date information stored in the system's CMOS (nonvolatile memory).The types of buses (for example, ISA, PCI, EISA, Micro Channel Architecture [MCA]) on the system and identifiers for devices attached to the buses.The number, size, and type of disk drives on the system.The types of mouse input devices connected to the system.The number and type of parallel ports configured on the system
Who is the holds and system date and time?
Which of the following holds the system date and time
Where is the saved BIOS configuration data sotred?
BIOS configuration data is stored in CMOS memory. That is where all the basic hardware settings are kept. CMOS has traditionally been volatile memory, so a battery is required. Newer BIOSes often use NVRAM.
List three ways that configuration information can be stored on a motherboard?
List three ways in whicn configuration information can be stored in a motherboard
Motherboard settings are stored in a small amount of RAM located on the firmware chip and are called?
CMOS or BIOS configuration settings
Cmos setup allows a technician to change configuration settings on a motherboard stored in what?
firmware chip
What is the prupose of a CMOS?
It keeps so called internal hardware time and settings related to current hardware configuration, boot order and so on.
What system component stores most of the PCs configuration information?
CMOS RAM
Where is the system date and time stored in the hard drive?
In the CMOS. System CMOS Date/Time is stored in the configuration settings in memory timing to be used by BIOS upon startup. RAM located on the motherboard must have continuous power to maintain the data (Date/Time). When time begins to read slowly or fails to keep up with current time it is a significant clue that the battery for CMOS is fading or may be dead and should be replaced.
Where the system date and time is stored?
it should be there in bios..
Where is cmos setup stored?
Cmos ram.
What is a device that contains firmware that provides support for all hardware devices and features on a system?
CMOS
What is bios and cmos?
BIOS = Basic Input Output System CMOS = Copper-Metal Oxide Semiconductor BIOS is the interface which is built-in to a computer system's firmware used to configure the computer system hardware in very basic ways. BIOS can be used to enable or disable hardware integrated into the motherboard such as IDE controllers, USB hosts, audio controllers, video, and more. It is often accessed by pressing F2 during startup, but this can change from manufacturer to manufacturer. CMOS is a type of circuitry often powered by a battery which allows the information in BIOS to be stored. If the CMOS battery is drained or removed all the system configuration data in BIOS will be reset to factory defaults every time the computer is shut off. These small batteries are also commonly used in calculators, hearing aides, and wristwatches. Due to the close relationship between the BIOS and the CMOS in the computer system, the two phrases are often incorrectly used as synonyms for each other. Some users will refer to opening the BIOS menu as "going into CMOS" or replacing the CMOS battery as "fixing the BIOS battery." However, none of this is seen as grammatically incorrect in common day-to-day conversation.
What is the difference between BIOS an firmware?
CMOS is a semiconductor chip of SRAM (Static Random Access Memory); while BIOS is executable code stored in ROM. The CMOS chip is an ultra low power memory, that can retain its data with only a simple watch type battery for a long time. Computers often store hardware configuration information in CMOS RAM. BIOS is the programming that a computer uses during power on to get booted. It is also often the interface between the software and the hardware. BIOS used to be stored in read-only memory (ROM), and as such, was unchangeable; but more recently, BIOS is stored on an EEPROM (Electronically Erasable Programmable Read-Only Memory); this allows for the ability to upgrade the BIOS code to provide support for changes in technology, or repair bugs discovered in the older code. BIOS = Basic Input Output System CMOS = Complementary Metal-Oxide-Semiconductor BIOS is the interface which is built-in to a computer system's firmware used to configure the computer system hardware in very basic ways. BIOS can be used to enable or disable hardware integrated into the motherboard such as IDE controllers, USB hosts, audio controllers, video, and more. It is often accessed by pressing F2 during startup, but this can change from manufacturer to manufacturer. CMOS is a type of battery often used to power the circuit which allows the information in BIOS to be stored. If the CMOS battery is drained or removed all the system configuration data in BIOS will be reset to factory defaults every time the computer is shut off. CMOS batteries are also commonly used in calculators, hearing aides, and wristwatches. Due to the close relationship between BIOS and the CMOS battery in the computer system, the two phrases are often incorrectly used as synonyms for each other. Some users will refer to opening the BIOS menu as "going into CMOS" or replacing the CMOS battery as "fixing the BIOS battery." However, none of this is seen as grammatically incorrect in common day-to-day conversation.
