Timing and idle setting maybe computer controlled and not adjustable. If they are adjustable should be 825-850 RPM
According to the Gates website ( they make timing belts etcetera ) Yes , the 1.3 liter four cylinder engine in a 1990 Ford Festiva has a timing BELT
ford festiva stopped while driving it has fuel and power it just wont turn over
just the top one that is the vacum advance, timing should be 2 degrees BTDC with vacum advance line removed and blocke
You need a timing light to set the correct timing. Once the truck has been set at base timing at 0-2 degrees by disconnecting the timing wire and setting the dist., the computer adjusts the timing by itself to the proper setting.. There is not an adjustment for the the idle speed on this truck.
The timing on a 1999 Honda Civic can be adjusted setting the distributor to the correct angle. Setting the distributor forward to much will mess with original settings of the ignition.
60 thousand miles and it is not easy, and when you replace make sure you have all the timing absolutely correct, Declan.
Unless you have had the timing belt off or it has broken the timing should still be correct. The way you set the timing is by taking the timing belt off and lining up the timing marks and put the belt back on. I added a link to a text how-to for setting the timing on the Zetec engine. -ZX2Fast
Correct timing is what ever the manufacture recommends.
setting timing on a f150 4.9 6cyl
The timing should not need setting unless you have a failed timing belt or head repair of sorts. after the new parts for the head are all in place set no 1 piston to top dead center, line the cam sprocket and the crank so both timing marks are together going north south put on the timing belt and tighten the pensioner up you have base timing hook up a timing light loosen the distributor and locate the timing window on the bell housing (near the head) mark the recommended setting with a white marker and and the required setting on the window. start the engine and using your light line up your setting or as you desire!
there is no timing on a water pump pump is belt driven and just turns when motor is running
Ignition timing is set on a 1989 Acura Integra by setting the distributor to the appropriate angle. When set at the factory recommended angle the car will turn over with no problems.
Correct timing setting is very easy to set, but one cannot tell you what you must set it to, especially if you want to fine tune it. Because it varies between countries due to ultitude and sea level conditions. Best possible answer would be to put it back to what you manual says i.e 10degrees for an exampleTiming is set by aligning the timing belt marks with the cam shaft sprockets and the crank pulley.
If the marks on the sprockets line up with the plated links, the timing is correct.
There is no timing adjustment, The computer controlls the timing.
The timing setting for a 1988 Toyota Tercel is the "3E" hole lines at the top. This setting is for a Tercel EZ 1500 engine.
Hoo I set the correct timing on a 1993 mazda protege
Timing belt. Recommended 90,000 mile change.
a timing gun
what are the timing belt setting for a 1993 Isuzu trooper 3.2 ltr v6 ...
The timing chain does not have a recommended change interval and should last for the life of the engine.The timing chain does not have a recommended change interval and should last for the life of the engine.
The correct timing for a Mercruiser 3.0L 140 engine is 6 degrees BTDC. for a Mercruiser 120 the correct timing is 8 degree BTDC.