Ford Explorer

Is the slave cylinder located inside the transmission inside a ford explorer?

345

Top Answer
User Avatar
Wiki User
Answered
2008-05-18 14:25:34
2008-05-18 14:25:34

Yes , the slave cylinder for your manual transmission clutch is inside the transmission bellhousing , it slides over the input shaft of your transmission and is bolted to the transmission

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


Inside the manual transmission bellhousing


The slave cylinder for your hydraulic clutch is located inside the manual transmission bellhousing


The slave cylinder for a hydraulic clutch is located inside the manual transmission bellhousing


It depends on where the slave cylinder is located. If it is inside the bell housing you will have to remove the transmission.


The slave cylinder for your hydraulic clutch is located inside the transmission bell housing


The clutch master cylinder is in the engine compartment and the slave cylinder for the hydraulic clutch is inside the manual transmission bellhousing


The clutch slave cylinder is located inside the transmission bellhousing. The transmission must be removed to gain access.


The slave cylinder for a hydraulic clutch is located inside the manual transmission bellhousing


The clutch master cylinder is in your engine compartment , the hydraulic clutch slave cylinder is inside your manual transmission bell housing


It is attached to the valve body of the transmission inside the transmission oil pan. wich one of the six solenoids inside oil pan?


The slave cylinder for the hydraulic clutch on a manual transmission is located inside the manual transmission bell housing


Inside the transmission.Inside the transmission.


The slave cylinder is INSIDE the transmission bellhousing , it slides over the transmission input shaft , and then is bolted to the transmission. To change the slave cylinder the transmission has to be removed , but the slave cylinder line can be blead from the bleeder outside of the transmission bellhousing


Yes , the slave cylinder for your hydraulic clutch is inside the manual transmission bell housing. It slides over the input shaft to the transmission and is bolted in place inside the transmission . To CHANGE the slave cylinder the transmission has to be removed , but the lines to the slave cylinder CAN BE BLEAD from a fitting that extends outside of the transmission bellhousing


The turbine shaft speed (TSS) sensor is located inside the automatic transmission.


The torque converter for an automatic transmission is inside the bellhousing area of the automatic transmission , the end of the transmission that is bolted to the engine



the clutch slave cylinder on this car is located inside the transmission itself. The part has a rubber bushing that separates the the hydraulic lines and bleeder, from the section that is located in the transmission housing itself.


I'm not a mechanic / technician , but as far as I know the manual transmission has to be removed in order to replace the hydraulic clutch slave cylinder


Remove the exaust pipes. Remove the transmission. It is located inside the bell housing section of the transmission.


The oil pump is bolted to the bottom of the engine INSIDE the oil pan


The transmission filter is located inside the transmission.


Inside the transmission pan.Inside the transmission pan.



There are numerous sensors on and inside the transmission.There are numerous sensors on and inside the transmission.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.