answersLogoWhite

0


Best Answer

Have you checked the bulbs themselves? The directional signal should be the same element as the brake light. Check to see if you rear directional signals.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Is there a brake light relay on a 1998 ford F 150 you checked all mini fuses replaced the brake light switch no brake lights work?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

Brake lights do not work all the time replaced brake light switch?

If you have the same bulb for brake and signal, brake light power needs to be interrupted by the signal lights, The brake circuit has to go through the signal light switch so the problem could be there.


If your brake lights do not come on until touching the floor board what would you do to increase sensitivity or what would you replace?

Adjust the brake switch located on either the brake lever itself, or it will be attached underneath the dash. SOunds like your brake switch is off or broken. Look at the brake pedal and there is a switch around it that gets activated by you pushing the pedal - that is what needs to be adjusted or replaced. The brake light switch has probably come loose or broken. Look under the dash near the brake pedal arm. There is a switch attached to a bracket.


What is the name of the small rubber piece that is located under the brake pedal that turns off the tail lights?

The part of the car that turns on the brake lights when you apply pressure to the brake pedal is called the brake switch. Releasing pressure from the pedal causes the brake switch to break its electrical contact, turning off the lights.


Why do you have to pump on the brakes to get the brake lights to come on?

You need to adjust your brake light switch. It should be located on the brake pedal. Unplug the switch and loosen the nuts to adjust the button closer to the brake pedal.


2002 ford explorer brake lights stay on all the time?

check brake light fuse and brake light switch on pedal

Related questions

Why wont the brake lights on your 1998 dodge stratus work Ive checked all the fuses and replaced the brake light switch They still won't work?

try the multifunction switch located on the steering column .


All of your brake lights are out checked fuses and are ok?

Bad bulbs or brake light switch.


Fix this problem with your carlast night you were driving home from work and the police pulled you over cuz your all the brake light not orking the three of themi replaced all of them and you checked?

usually faulty brake lights are either the brake light switch that senses when you press on the brake pedal, a connector somewhere between the brake light switch and the brake lights or the turn signal switch.


Brake lights dont work on my 98 gmc jimmy Ireplaced bulb and I replaced switch under brake pedal lights still dont work?

Did you replace the fuse? have you checked the circuit board well the lights go on cause they tend to short out often


Why would the high beams work but not low beams and break and tail lights only work if instrument panel lights work 1986 300zx have checked bulbs and fuses replaced switch behind brake pedal?

headlight switch


What would cause the brake lights to not light up we checked fuses light bulbs are good the brake switch was replaced and still nothing can you guys help?

ya its called go to a mechanic you idiot


Why won't the brake lights shut off on a 1998 Cadillac Catera?

Brake switch needs replaced.


Brake lights on 2001 dodge stratus do not work Checked fuses bulbs and replaced stop switch Any suggestions?

check the bulb again, are BOTH filaments good


Why would the brake lights stay on whenever the car is on even after you have replaced the brake light switch?

Out of adjustment. Adjust the mounting of the switch so the brakes lights are off until you press the brake pedal.


Where can you find a diagram of brake system for 1986 Chevy pickup?

i have tail lights but do not have brake lights nor do i have turn signals. i have replaced brake switch and all bulbs


What is wrong if the stoplights don't work but the tail lights and rear signal lights work and the stop light light bulbs have been replaced and the fuses checked?

brake light switch bad check for continuity at the fuse then the switch, but yeah bad switch. Kongkit Raggan-Supatanampon


When I turn on my Headlights my brake lights stay on. I have replaced the brake light switch and checked all fuses What else can you check 97 Corolla?

i would heck that you have the correct double element bulbs in your tail light assembly