answersLogoWhite

0


Best Answer
Copy

I own a '91 GL and no there is not. It sounds like you may have an issue with your ignition lock being stuck. Have never taken apart an ignition before. -Shaun

User Avatar

Wiki User

โˆ™ 2006-05-16 15:28:16
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +5 pts
Q: Is there a button somewhere that releases the key so you can get it out of the ignition in a 1991 Ford Probe GL?
Write your answer...
Submit

Related Questions

Why does Ford Probe ignition stays on even when key is not in ignition?

Defective ignition switch or tumbler assembly.


Where is the dura spark ignition module located on a 1991 Ford probe?

The 1991 Ford Probe spark ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.


Where is the ignition coil in a 1995 ford probe gt?

Built into the distributor.


How do you set the ignition timing on a ford probe gt 95 with an mx engine?

To set the ignition timing on a Ford Probe GT 95 with an MX engine, remove the two 12 mm head bolts holding the distributor in place. Then rotate the distributor to set the ignition timing.


What is the difference between a probe a satellite and a rover?

A satellite goes around a planet. A probe goes "somewhere". A rover moves about on the surface of a planet.


Where is the ignition module on a 1993 Ford Probe 4 cylinder?

In the dist. Takeit to Auto zone and have them check it out.


How do you set ignition timing on a 1995 Ford Probe?

there are two dots on the distributor they have to be lined up on tdc


Where is the fuel reset button located on a 1991 Ford Probe?

i don't know about a probe forsure but is in the trunk on a tompo or topaz on th left side near the top


Where in the trunk is the auto shut off button on a 94 Ford Probe GT?

its in the left side under the carpet. if there is a button sticking out push it back in.


What is Ignition timing 1990 Ford Probe 2.2?

motorcraft.com shows for the 1990 Ford Probe 2.2 L ( 133 cubic inch ) 4 cylinder : ignition timing : 6 degrees BTDC , and --------------------------------------------------------------------------------------------------------- 9 degrees BTDC - manual transmission - with turbo - with self test connector grounded


How do space probes get into space?

They get loaded in to a rockoet. then sent into space where the rocket breaks up and releases the probe to where ever it needs to go


Where is the location of ignition control module for 1996 Probe 2.0?

it should be located under the battery on the inside of the front fender.


How do you set ignition timing on a 1989 ford probe?

where are timing marks on 89 ford probe 4 cylinder I have the bottom not the top


How do you start your car when the key won't turn in the ignition?

Its a 94 Probe and my son stuck the key in tonight and the car wont turn on


How to reset a fuel switch located in the trunk of a 1992 ford probe?

in this case its ok to push the red button


Is there a reset button for the fuel pump on an 89 ford probe and where would it be?

Owner's manual will point you to the location. Usually in the trunk. In my 89 Probe, the reset is in the trunk on the driver's side in front of the wiper fluid resevior.


What happens if the OD button in the 95 ford probe is disabled?

if OD button is disabled, the transmission will not shift into overdrive. your car will be running with one less gear, and using more fuel


Why do the Distributor unit fails on 1995 Ford Probe GT?

There is a small ignition module (relay) that is built into the distributor that is notorious for burning up.....


Where can you buy a ignition control module in the distibutor type for your 1993 Probe 4-cylinder automatic?

You can't. it's integrated. Do a HEI-mod instead, cheaper and more effective. Do a search on google for Hei-mod +ford probe.


How do you remove the ignition key switch on a 94 probe?

Disconnect the negative battery cable. Remove steering column covers Disconnect the electrical connector from the ignition switch Remove the screw retaining the switch to the steering column


What is the probe size?

Probe,probe se 2.0 / probe gt 2.5


What is man shift on a 1990 Ford Probe for?

a man shift is a manuel shift button it drops the car down a gear for passing and such


Where is the coil on a 1993 Ford Probe gt?

On the '93-'97 GT's the ignition coil is part of the distributor. If your coil goes bad you need to change the distributor.


How do you set speed limit to cruise control of ford probe lx 1989?

I have a 1989 Probe LX. 1. make sure the button on the cruise control is IN 2. press the button on the end of the stalk at desired speed. 3. setting can then be changed up/down by raising or lowering the stalk. 4. the 'speed alarm' function has nothing to do with the cruise control.


What is the population of Gen-Probe?

The population of Gen-Probe is 1,300.