call 419-782-9900 at Ohio parts they can hook you up with a cat back direct bolt on system,unless your looking for high performance in that case I'm looking too!
That would be the 5.7L / 350 Vortec.
There are no 2 rear doors.
is it a 2door or 4 door ?
The hood ornament should be the flying jet enblem.
Look in your owner's manual.
A base 2 dr. dart in 1966 was about $2,500.
Dealer would have to run VIN ( vehicel id number)
No, the door on a 1998 Ford Explorer will not fit a 1992 Ford Explorer.
GT Coupes = 967, GT Sedan = 2,871, GTP Coupes = 1,128, GTP Sedans = 2,256
there are 2 sizes. 1 is 2door 11.1 gal 2 other is 4door. 14.5 gal
A 2WD Tahoe does not have torsion adjustment bolts, it uses front coil springs and not torsion bars.
I was told from a friend who works for GM and is a 2door 2wheeldrive owner as I am they made 414 in 1999.
The car that is parked in their front yard is a 1950ish vintage Nash station wagon. The car is a 1949/1950 Nash Airflyte 2door sedan. It is not a station wagon.
under the left side of the dash around where the hood release latch is.
Your Starter is located at the front of the engine near the transmission. You need to take off two wires running to the starter and then two bolts holding it on. It's very easy.
there are 16 Bushing body mount pieces. 8 per side of the truck.
The standard features of a 1959 Chevrolet Impala are a new X-frame Chassis. The standard model was a 2door but 4door models were available. Also it was available in 3speed manual and 2speed automatic transmission.
Australia ,mate.The Pontiac g8 and there 2door G.T.O from around 2000 are basicly a chev motor put into an Aussie body.G.M(USA) and Holden,have ties going back to 1930's,give or take 10years.
Door panels for a 1975 Chevy Caprice Classic 2 door might be found in a salvage yard. Rock Auto is also a good source for aftermarket parts for most vehicles.
Sticky/stuck caliper slides, sticky/stuck caliper piston, collapsed brake hose, pinched brake line,
4 wheel parts has them check them out i also saw a explorer kit that did the same pa body lift will help you if all else fails wish u the best i am doing the same to mine
check this link out. its got the step by step guide. http://www.fitaudio.com/?View=entry&EntryID=157 However if your looking for how to do it on the 2door coupe version like myself, well im still looking lol...