0
Depends on the vehicle. Some are the same if you have rack and pinion steering. If you have a standard steering box with a center link, left and right are different.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
What is the difference between gram-positive cocci and gram-negative rods?
Look at them under a microscope! If they are cocci, they will look like balls. If they are rods, they will look like...rods!
What is functional difference between rods and cones?
One is for daylight conditions and one is for evening/nighttime conditions.
What is the difference between hot rods and muscle cars?
A muscle car is factory built, and a hot rod, home built.
The difference between enterobacter aerogenes and citrobacter freundii?
the enterobacter spp when viewed under the microscope are gram negative rods,but their rods are longer than that of the citrobacter allthough it is also a gram negative organism
Is the crankshaft usually on the left or right side of the block on Ford vehicles?
The crank shaft runs right down the middle of the lower engine. The connecting rods & pistons are attached to it.
How can you use four rods that measure 2 centimeters 5 centimeters 7 centimeters and 9 centimeters to measure a length of 1 centimeters?
Put the 7cm and 5 cm rods together = 12 cm Put the 9cm and 2cm rods together = 11 cm Difference between is 1cm thus, you can use that difference to measure 1 cm.
What is the difference between rods and cones?
cone cells help you see colors while rod cells helps you see in dim light
Where is spare tire rods for suburban 2000?
I can only answer this for a 2000 Suburban. Lift out the middle tray on the Left side of the truck right next to the third seat. Right next to the left rear side glass. The tools are hidden in the compartment right below the left rear side glass. Hope this helps.
The chain reaction in a nuclear reactor is controlled by inserting what?
control rods.
What is the difference in welding rods 7014 verses e7014?
None
Where is the starter location for a 2004 Hyundai Elantra?
its just behind the engine and can easily seen from left side between two rods supporting the starter
How can you get curtain rods to stay in place if there is no hole in the bracket to secure the rod into the bracket?
You can insert two screws or nails in the back of the rod for each bracket to prevent the latter from moving left or right. the space between the screws should be the same as the width of the bracket.
