No. The the same part number is applicable for both driver and passenger side windows. Front and rear are also the same.
no.. very different.. by hard top you mean 4 door..?.. the 4 door window mech is a scissors action.... the convert is on a frame and cabled..
Yes! If you have a zipout window. It will require top half open. Then the lower panel removal, re-stapling of the new meterial to the panel. Good luck tight fit.
I was just searching the list and there is an answer to a similar question already in FAQ
Knowing the way Chrysler often interchanges parts from many different cars, I would assume it would be about the same.
yes, it should theyre mostly the same in those years Yes, it fits! Even the windshield from the coupé fits in the convertible and the one from the convertible fits to the coupé. As they are glued, they are not easy to bring out without crack, take care, U use a good tool for this. On the LeBarons newer than 1992, the Mirrors are not glued to the window anymore
On eBay there about $160 to $200 dependiing on if you need the rear window. You'll have to remove back seats to get at the complete convertible frame. The tops will come with instructions. Its a lot of work and very time consuming plan for a whole weekend.
Unlatch the latches at the top of the window, then press the convertible top button down. this button is located near the armrest. If this does not work you must aquire a new convertible top motor. from the trunk, remove hyd. fluid from the conv. top pump, operate top by hand. worked for me for years
You have to remove the back seats.. and then the panels.. windows are held in by 10mm bolts.. disconnect the connectors at the bottom if the window unit.. Allow an hour to do this.. PIA job
w
I wouldn't.
A mirror is reflective an window is transparent or translucent
Window = Singular Windows = Plural