Not inside, the crankshaft position sensor goes through the top passenger side though.
The 1997 Dodge Dakota air intake sensor can be found attached to the air cleaner housing. The air intake sensor will be on the inside of the air cleaner housing.
sensor should be a little to the passenger side on the top of the clutch housing where the bell housing bolts to it.
The 1994 Dodge Intrepid O2 sensor is located on the outside of the air cleaner housing. The sensor is on the back side of the housing.
Beside the thermostat housing.
The 1988 Dodge Dynasty coolant fan sensor is located a few inches above the thermostat housing. The thermostat housing can be found on the front of the engine.
The coolant sensor is the two wire sensor that is next to the thermostat housing.
It is the two wire sensor near the thermostat housing.
It is inside the hvac housing under the dash.It is inside the hvac housing under the dash.
rear rght side of motor- remove the inside cover and you will see it on the top right side by the bell housing
The backup sensor is inside the transmission.
trany bell housing
beside the thermostat housing