Pontiac Grand Prix
Grand Prix GTP
Grand Prix SE

Is there a trick to replace the ac-heater core cover on a 95 Pontiac Grand Prix?

111213

Top Answer
User Avatar
Wiki User
2007-10-15 00:16:57
2007-10-15 00:16:57

the trick is to remove the center console. the heater core is directly behind it.the problem i am having is removing the shifter knob to remove the console as soon as i figure that out i will post what i find the shifter knob is easily removed by using a small screwdriver to engage a clip looks like a staple from the forward surface of the shift plastic handle my handle would not come off with just my feeble strength but did with a block of wood and a curved screwdriver use gentle pressure and it will pop right off

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

where is valve cover located on a 2001 Pontiac Grand-Am 4 cyl

User Avatar

To replace a Pontiac Grand Am bumper cover, start by taking out either the three bolts on the side of the fender or in front of the wheels. Remove the top pushpins to remove the cover. Push back the two pins for each headlight, and pull them up. Unplug the lights. Then, get the replacement bumper, and snap it into place like the previous one.

User Avatar

What do you mean by headlight cover?What are you trying to do?JW

User Avatar

To replace the dome light on a Grand Am, unscrew the light cover. Pull it down gently. Disconnect the light. Connect the new light, replace the light cover, and replace the screws.

User Avatar

It is probably the cover for your catalytic converter.

User Avatar

The 1995 Pontiac Grand Am 3.1 liter engine crank shaft sensor is located inside of the rear engine cover. You will need to remove the rear engine cover in order to access the crankshaft sensor.

User Avatar

On the bottom of the dash on the passenger side remove the black cover then remove the bolts on the blower and disconnect the wire. Reverse above to install.

User Avatar

1992 Pontiac grand am ac relay locationi found the relays. they are in the center of the firewall next to the blower case. they are in a case with cover that is bolted to the firewall.

User Avatar

remove the spark plug cover. and the valve cover to reach it its right under the cam pulley

User Avatar

Refrigerant is added to a 1997 Pontiac Grand Am by removing the cover on the low pressure coolant line and attaching a can of refrigerant. The valve on the can is then opened and the system will automatically pull the refrigerant in.

User Avatar

usually on back of fuse cover n in owners manual

User Avatar

on top of the engine underneath the cover. you cant miss it.

User Avatar

driver side of the front valve cover if its the V6 if its the 4 cyl. its on the top of the valve cover somewhere

User Avatar

Should be able to just unbolt the valve cover, remove the old gasket clear the surfaces with a rag and reinstall. Might have to disconnect the throttle/trans kickdown cable from the throttle body for room.

User Avatar

It is located behind the timing chain cover under the exhaust manifold.

User Avatar

either tighten the valve cover bolts, or replace the gaskets.

User Avatar

On the clear cover press firmly on each side and the cover should come off. The bulb just sorta snaps in. Don't try to pry off the entire fixture or you will break off the holding studs and end up having to replace the entire dome light fixture...

User Avatar

If your key is stuck: on the underside of the steering column cover there is a round recess cover. Remove the cover and using a pecil push up through the recess.

User Avatar

on top of the engine there is a cover sheild. remove the cover by the four bolt. the plug boots will come with it, the spark plugs are down in the holes.

User Avatar

The 1993 Pontiac Grand Am fuse diagram can be found on the inside cover of the fuse box. The diagram can also be obtained from most General Motors dealerships.

User Avatar

The 1999 Pontiac Grand Am speakers can be removed by removing the speaker cover. The speaker cover is held in place with two screws. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.