answersLogoWhite
Spark Plugs and Wires
Oil and Oil Filters
Rover 75 Series

Is there a washer on the sump plug for rover 75 v6?


Top Answer
User Avatar
Wiki User
Answered 2011-01-23 21:11:53

yeah

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


you can find the sump plug in rover spares department.


Underneath the engine on the sump ( or in USA terms the oil pan)


on the bottom of the sump, i think it is a 19mm hex bolt, it does not look like a sump plug it looks like a mounting bolt for the engine but if you can get the car high enough and get good light in you will see it o.k.


How do i time rover 75 v6 engine/


Rover 75 Under bonnet fuel pump - WQB100482 - Roughly £180 Rover 75 Under bonnet fuel pump - WQB100482 - Roughly £180


in my opinion yes, i got my 75 rover a while back and it still works perfectly


where is the parking buzzer located in the rover 75 .its somewere in the front but i cant find were as it has stoped working


The height of the 2006 Land-Rover Range-Rover is 6 ft. 3 in. (75 in.).


you have to take to a rover dealer to put out the service light


i have a rover 75, 1.8. it has about 26,000 miles on clock. when does my timing belt need changing


under the rear seat on the drivers side on a v6 75


There are extensive guides on the Rover Owners Club forums. Google it!


The starter motor is at the rear of the engine.



Difficult to work on and lots of garages wouldn't touch mine which is a Rover 75 V6 auto. I got a garage to carry out repair for about


if it has one, which is unlikely because it is pre 2004, when these were introduced for diesels, it will be within 30 cm or so of the driver's right knee, possibly under a flap somewhere.


Rover 75's can be fitted with Subaru alloys. Mabe others too. Would be good to find out.


The correct plug gap for the 1975 model, 75 hp Evinrude, is .032 in.


It is at the front side of engine next to the trainsmission



Bring all keys and FOBs to dealership.


Its in the plenum camber. The most idiotic place on the car.



To bleed the clutch of a Rover 75, first remove the interior panels on the steering column. Second, remove the master cylinder and use a syringe to inject the fluid into the system and repeat 4 times to bleed the clutch.


No, take a look under steering wheel. No OBDII port



Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.