Yes you can connect it right to the hot wire along with the Main B+ but why? Most car stereo have a wire for electric antennas (labeled as such) and they are very handy to turn on the amp especially if you want to connect the amp main B+ right to the battery for high current which is desirable, you can also probe the fuse box with a voltmeter and find a fuse that only has power when the key is on or in ACC.
The reason being y i dont want to use the remote activation is because im going iPod amp speakers and my ipod dosent have a remote activation. If the dont know its there then they wont look to steal it
No, have to use line-out converters.
Remove the retaining cover from your factory stereo. Remove the factory stereo retaining bolts. Slide the factory stereo out. Remove the wiring harness and the antenna cable from the back of the factory stereo.
Remove the 2002 Dodge Durango factory stereo decorative cover. Remove the factory stereo retaining screws. Pull the factory stereo out. Remove the wiring harness and the antenna cable from the back of the stereo.
Why bypass amp just get wiring diagram and hook up remote"blue wire" to the remote lead from factory amp. Or unplug amp use a meter and check which wire has power. Then turn off radio and check wire again should have no power with radio off. This will only work if factory radio is still installed. But that wire would be remote wire. Just hook up new radio remote wire to the found wire. Then connect speakers to factory plugs and use the amp.
How to remove factory stereo from 2001 honda civic?
You must be careful the factory wire colors are not the same. A blue factory wire is not a remote wire like the headunit. Go to www.the12volt.com they have free factory wiring diagrams. If you need help feel free to contact me
What part is required to connect a mono amp to a factory stereo
Where is factory stereo amp located on a 2007 Cadillac cts
== == == ==
color codes for wiring on factory stereo on 2008 Nissan sentra?
No remote wire on stock deck tap into igniton wire (yellow with black stripe) for 1999 ford rangers & Mazda B-series.
To remove the factory stereo on 1996 dodge ram 1500 you need to pop the hood on the Ram and remove the ashtray. Slide the stereo out of the dash and unplug the cables from the back of the stereo.
i would go to best buy or call the company that manufactured/sold you the stereo
not the factory, but any dealership will do
Hello Did you find out? Ive had trouble installing my stereo as well. email@example.com
== == == == == == == ==
Depends which color u are talking about blue is for antenna if ur car has blue/white is a remote turn on for amps including factory or aftermarket
More than likely the factory amp(located under the drivers seat) has failed. All speaker wires feed into it, but only the rear speakers are amplified. They are cheap and fail, so it may be wise to just replace/upgrade to an aftermarket stereo. If you feel good about wiring, you can rewire the amp connections to bypass it, or there is a couple sites that offer bypass cables.
Please visit my bio for access to my Saturn help site. here you will find a diagram of the factory wireing to assist you in installing your aftermarket radio.
I have just installed a indash in my infiniti i30 1998. The amp and subwoofers work but the speakers in the inside of the car does not work. Did I blow a fuse or do I have to bypass the factory amps. The system that I took out before the installation was a factory bose system.
The cast of The Stereo Flys in the Sunshine Factory - 2010 includes: Jeff Beam as Stereo Fly - Guitars, Keys and Vocals Zander Kagle as Stereo Fly - Drums and Percussion Sam Peisner as Stereo Fly - Bass, Gong, Thunder and Vocals
The factory stereo didn't have an external amplifer.