Yes I would like to know this also 'cause when I tried removing the head lamp it would not come all the way out and kept getting stuck. In the manual when I looked under body and trim it showed a picture of removing the front fascia(plastic bumper cover that contains front turn signal lamp) and states that should remove signal housing from this fascia...what a job to replace turn signal bulb...remove front bumper that contains it. Check out manual on autozone.com for free.
You can replace the ignition lock cylinder in your 1994 Pontiac Firebird without removing the steering will. Remove the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out.
The alternator on a Pontiac Aztek is replaced by removing the engine accessories, loosening the serpentine belt, and removing the retaining bolts. The alternator can then be pulled from its retaining bracket and a new one installed.
You need to replace the DRL (Daytime running light) Module
Had the same problem in my 1990 2500. I could get parking lights but when I went to full headlights it killed the truck. Oddly replace the switch (the one with the pull knob) to resolve. Pay attn to those directions as removing the knob is one of the first things to do and the rest is pretty easy. Additionally you should be able to do it with only removing the lower plastic, allows you to get your hands in there.
Don't try and clean them ...just replace why should i try not to fix it myself it is cheaper
I'd be tempted to replace the head lamps before I replaced the switch. You're looking at a cost factor of about $25 to replace the lamps vs $65 or $70 for the switch. Be sure to check for the obvious things like fuses or broken wires first. Could be there's a loose, broken or dirty ground connection to the headlights.
It might be the high/low beam switch. Had to replace one on my '96 when I had only low beams.
instruction on how to replace headlights on 2006 murano
Dash lights are usually wired in the parking/taillight circuit Try removing the bulbs from these, check sockets and replace bulbs one at a time . Hopefully short will be in one of these and not under dash
You don't. You replace the worn out rear break shoes. If that doesn't do it you need to replace the stretched E brake cable.
You need to periodically replace the headlights on your Chevy truck when the headlights start getting dim. You can purchase replacement headlights from retailers such as Parts Source.
You can replace the sheer core, on your 2004 Pontiac Grand Prix, by removing the water lines. Remove the four bolts that hold the heater core in place. Reverse the process to install the new heater core.
98' headlights look better
it would be best because you could tear the old ones while removing them.
sounds like the fuel sensor inthe fuel tank which means removing tank to replace
The rear shocks on a Pontiac G6 are replaced by supporting the rear axle on jack stands, removing the wheels, and unbolting the shocks. New shocks can then be put in place and bolted on.
How do you replace the alternator on a 1988 Pontiac Fiero
please helpp me replace a oil pump for my 94 grand prix, I 'm having problems removing oil pan! what do I needto do ?
It is true to say that Halo headlights bulbs can be replaced.
You will have to take the bolts off the old headlights and simply replace the old headlight and screw the bolts back in.
how do you replace halo parking lights on 2004 530i bmw
replace the head light switch you may have a bad wire or a faulty dimmer switch.
how do I replace a parking lamp (left) on a 1996 Ford Taurus
To replace front parking light on a 1999 Ford Taurus, lift the hood and remove the bolt holding the parking light housing cover. Twist the parking light off and replace with a new one.