answersLogoWhite

0


Best Answer

yes it is located on the top of the manifold, back side of the motor next to the throttle assembly shield. It is electronically controlled

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Is there an egr valve sensor for a 1996 olds cutlass ciera?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is 1996 Oldsmobile Cutlass Supreme Position Sensor Location?

where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine


Where is the speed sensor located on a 1996 Oldsmobile cutlass ciera?

It should Be located on the top of the transmission.


Where is the fuse box on a 1996 Oldsmobile Cutlass Ciera?

IT IS IN THE GLOVE BOX INSIDE CAR


Where is the thermostat housing for 1996 Oldsmobile ciera cutlass?

follow the top radiator hose where it goes back to the egine


How long does it take to change a water pump in a 1996 Oldsmobile cutlass ciera with a 3.1?

bum willy bum


Where is the purge valve located on a 1996 Oldsmobile Cutlass Supreme?

wher is the pcv located on a 1996 olds cutlass supreme 3.4 l engine


1990 olds ciera and you would like to know if it is front wheel drive?

The Oldsmobile Cutlass Ciera a was front wheel drive model. It was sold by General Motors from 1982 to 1996.


What body parts on a 1993 Cutlass Ciera will interchange with other GM cars?

The body was basically the same on the Ciera from 1989-1996, so any parts from one of those years should work


1996 jimmy evap purge valve sensor where located?

where is the evap purge valve located in a 1996 jimmy


What would cause tail lights to stay on after turning off 1996 olds cutlass ciera 6-cylinder efi automatic?

Stuck brake light switch.


What is the problem when an Olds Cutlass Ciera 3.1 OBD code reads P1406?

The P1406 code on a 1996 Oldsmobile Cutlass Ciera 3.1 is the code for the EGR pintle position circuit. I know this because it was my question initially and we bought a code reader to check the problem. It is a factory specific code, so the answer is quite specific. Good luck !


What are the torque specs for the intake manifold fuel injection and valve adjustment on a 1996 Oldsmobile Cutlass Ciera 3.1L engine?

the torque specs for the intake manifold are 115 inch pounds inch pounds to newton meter = mutiply .113 by the number of inch pounds aprox. 9.5 foot pounds