answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2011-02-22 15:26:49
2011-02-22 15:26:49

Yes they make a turbo kit for it just matters what you won't to spend

001
🦃
0
🤨
0
😮
0
😂
0

Related Questions


Johnson outboards, model RDS-24L, would be a 1962 year model, 40 hp. the boat motor is a 50 hp.


Open the hood and look straight down on the front of the motor. It is in front of the motor by the fan.


I have a 2000, I'm sure they are the same..take the four bolts off the top cover (the one that says 2.4 or whatever) and carefully lift the piece out...there are plastic and rubber boots attaching the cover to the plugs.


I'm assuming you mean "hotwire"? Don't try it. You will fry the computer.




it is not to bad a job,i recommend you buy the service manual from autozone or advance because you need step by step instructions to do it. Before you do it check on availability of radiator as some of the earlier galants radiators are kinda scarce. Just means you will have to special order it in,thats all.


4 Runways which you can land both ways - so 8 in total... 6L/24R 6R/24L 7L/25R 7R/25L




I need a trigger guard of a Savage 24L-DL any help.I would start my search at Numrich Gun parts Corp.


1 mol N2 = 28g 30C = 303K At STP, 1mol * 273K is proportional 24L * 760torr. (PV = nRT) Then we do a little bit of stoichiometry... 10g * 1mol/28g * 24L*760torr/(1mol*273K) * 303K * xL/750torr = 9.6402 L 10.0g of N2 at 30C and 750torr should occupy 9.6402L




Flight AA832 on final approach to runway 24L. It was held up by weather over Kentucky, and arrived at an unusual time.


It has both. As a rule:--U-Joints are usually found on drive shafts and CV joints are usually found on half shafts.


http://www.autofixworld.com/index.php?option=com_content&task=view&id=379&Itemid=84


The 24L in a 2010 Dodge Avenger has a timing chain, not a belt. The timing chain should last the life of the car.


AnswerAll I know is that 1998 2.4 Cylinder head will fit on a 2002 2.4 as I sold mine to a guy rebuilding one. He did mention that sensor location was in a different spot but that was all.So some difference but not that much I guessI replaced a 1996 engine with a 1998. The '96 has a check oil sensor in the oil pan where the '98 does not. This doesn't affect the cars running, but you'll need to remove the 'check oil' bulb from the dash or swap oil pans to accomodate the '96 sensor. The anti-knock sensor is also different as the '96 uses a single wire sensor and the '98 uses a 2 wire. The A/K sensors also mount differently so you can't just swap them out. I jury-rigged a '96 sesor to press against the block and it works fine.


Best answer is to check the owner's manual. If car is missing that, go to a Chrysler dealer and pick a manual up. All fluid replacement intervals are spelled out in the manual.


More than likely 10W30. Your owner's manual will list the exact weight required. * I drive a 2000 Plymouth Breeze with a 2.4L engine. The owners manual recommends 5W30 weigt oil.


Presumably L, W, H mean length, width and height, and each one is expressed as a number of feet in size. To find the volume you find 24 x 19.75 x 29, and the answer is called "Cubic Feet".


You need a six extension and a spark plug socket with a rubber stop inside. The spark plugs are located on top of the engine. They are about 4 inchs inside the head. Using the extenion put the socket with the rubber piece inside which will grip the plugs when they are unscrewed allowing you to remove the plugs. When installing use the same socket but press the plugs inside the socket so they are being gripped which will you to slowing lower them inside the head with the extension and get them started. I suggest you start them by hand.


I have not pulled an oil pan on the model, however, most oil pans can be removed by removing the motor mount bolts and raising the engine up rather than pulling it, which is much less work.


Manchester Airport (MAN/EGCC) in the UK has 2 runways: 05L/23R - this is the original runway 05R/23L - this runway is the airport's 2nd runway and was opened in 2001 Runway numbers correspond to their magnetic headings to the nearest 10 degrees (so runway 23 faces approximately 230 degrees magnetic). Due to the nature of constantly changing magnetic variation runways occasionally require re-designating. As a result of this on 07/06/2007 Manchester re-designated their runways from 06L/24R and 06R/24L to 05L/23R and 05R/23L.



Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.