answersLogoWhite

0

This is normal and is caused by the weight of the wheels, and the dampers pushing them down. All you need to do to correct this is take the jack out from underneath the vehicle and drive it off, the wheels will settle down once you start driving.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you remove new beetle wheels?

A hubcap key is helpful in the removal of the New VW Beetle, a pair of Allen wrenches may be substituted in a pinch. Loosen the lug nuts prior to jacking up. Remove the nuts once jacked up, and pull up.


How do you remove the rear wheels on a 1987 seca?

The rear wheels are secured by five bolts and nuts. Remove the nuts to remove the wheels. Make sure the vehicle is jacked up before loosening the nuts.


How does front wheel drive work Won't both front wheels be pulling at once when jacked up front wheels off the ground?

n o


Where is the gearbox on 1974 vw super beetle?

between the rear wheels


How do you remove a Honda CB 750 engine?

This engine weighs 212 pounds. First, remove both wheels, the front forks and the swing arm. Remove all wiring and cables from the engine. Remove the carburetors. Then, remove engine mounting bolts except those at the bottom front and rear. Also remove the foot pegs. Next, remove top breather cover from engine. Remove oil filter and its housing. At this stage place the bike frame with the engine on its right side on some soft foam or blankets or such. Now you can remove the two remaining engine mounting bolts. The bike frame can be lifted off the engine at this point. Be careful with the engine mount tabs not to damage them.


What are the wheels called that receive power from the engine?

Drive wheels.


450 horsepower at the engine What is that at the wheels?

450 horsepower minus the power lost in the transition from the engine to the wheels.


How do you take Nissan 2.5 engine out?

Actually it's not a very hard task. Disconnect everything and mark everything....all of the electrical connectors at BOTH ends. When you remove fuel lines or vacuum lines, plug them and mark them as to where they go and what they are. There are three motor mounts, One on the right side of the engine compartment, one on the left side and one in the middle. Disconnect the exhaust system. Jack the vehicle up and remove the front wheels, disconnect the struts, wheel hubs ball joints and remove the drive axles. The vehicle can then be jacked up and the engine will come down through the bottom of the "frame". If you get yourself a Haynes Repair Manual at AutoZone for the vehicle,,,,the entire procedure is there.


What wheels will fit 1974 beetle?

Original size is 165R15, equivalent size is 165/80R15.


Can a 2013 Volkswagen Beetle be towed 4 wheels down Flat Towed?

Yes, a 2013 Volkswagen Beetle can be towed 4 wheel down Flat Towed.


How does the starter on a 1994 Grand Cherokee come off?

Remove NEGATIVE battery terminal Block wheels Crawl under car and remove lead wire and two mounting bolts. Slide starter motor backwards from engine. Reverse for installation. Remove NEGATIVE battery terminal Block wheels Crawl under car and remove lead wire and two mounting bolts. Slide starter motor backwards from engine. Reverse for installation.


Why don't humans have wheels?

Because cars have wheels and we would run on an engine and gas if we had wheels