0
Jeep ignition 1990 Cherokee Pioneer when starts runs strong it takes from 1 crank to 100 times to start it it shuts off randomly I replaced ignition cylinder and ignition switch won't start why?
Wiki User
∙ 16y ago
Check to see if you are getting spark (coil) and fuel
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you fix a leaking slave cylinder on 87 Jeep Cherokee Does it have to be replaced?
Yes, replace it.
96 jeep grand Cherokee that shut down you have replaced the coil fuel relay ASD relay fuel pump What else could it be There is no power to the dash board gauges fuel pump and ignition system?
Blown fuse or bad ignition switch or crank sensor?
The clutch on a 1988 Jeep Cherokee Chief won't disengage should the hydraulic master cylinder be replaced?
did you check your slave cylinder? is the hydraulic master cylinder leaking? did you try bleeding the clutch at all? what exactly does your pedal do? does it go straight to the floor or does it have pedal? there may be an air pocket in your lines? it could be alot of things you have to be more specific with your question
Can an internal voltage regulator be replaced on a 1996 jeep grand Cherokee or does the alternator have to be replaced?
The regulator is in the engine computer not the alternator.
96 Grand Cherokee shutTing off while driving?
I have a 96 Jeep Grand Cherokee Limited with a 4.0 litre six cylinder and 4x4 transmission. It has died on me several times while driving but was only a fuse on the passenger side under the hood. It was located in the section that says TRANS. When I replaced the fuse it started right up.
How do you fix a leaking slave cylinder on 87 Jeep Cherokee Does it have to be replaced?
Yes, replace it.
How do you fix a p0351 ignition coil primary secondary malfunction on a 1996 jeep grand Cherokee?
Have you already replaced the coil?
Remove ignition lock cylinder 2006 chev cobalt?
The ignition lock cylinder on a 2006 Chevy Cobalt is removed by popping off the steering column cover and inserting a screwdriver into the release hole. The cylinder can then be pulled from its housing and replaced.
How do you unlock a 1991 Chrysler lhs ignition?
There wasn't a 1991 lhs. If the key will not turn, the cylinder Will need replaced.
Why does your third cylinder partially fire in a 2002 Toyota Echo--you have replaced the ignition coil and injector already?
See related link.
Does the ignition key also open the trunk and doors for a 1994 chrysler lebaron?
It did when new. It should still unless a key cylinder has been replaced.It did when new. It should still unless a key cylinder has been replaced.
How do you replace an ignition Chevy Venture?
Leave it to the pros you have to key the cylinder when it is replaced and it involves tiny springs and tumblers if you mess up you key will not work
Replaced 2001 Saturn sl1 ignition cylinder twice oem still can not go back past accessory or it locks takes forever to play with the wheel and jiggle key to move it whats next thanks?
When the cylinder was replaced, did you get new keys for it also? Using a worn key has this type of symptom regardless of the cylinder.
How would you replace a ignition key if you lost the only one on a 92 olds 98 regancy?
A dealer can look up the ignition codes to make a key if one needs to be replaced on a 1992 Olds 98. A locksmith can also help but the ignition cylinder has to be removed.
What else could be wrong besides cylinder 1 ignition coil when the service engine light codes indicate cylinder 1 misfire and Knock?
I had the same problem and went ahead and replaced cylinder 1 coil and all the spark plugs and it worked.
Does a cutlass have three ignition coils?
If your car has EIS ignition ( distributorless) and it is a 6 cylinder, then you have three separate coil packs. They are all grouped together, however, they can be replaced individually. Each coil pack fires two cylinders.
You ve got fuel spark replaced ignition and fuel pump good too can runs fine but wont start randomly code ecu says 16 fuel injectors?
fuel pressure regulator
