0
Just installed a new shower pressure balancing set and water leaks out the shower head when you turn the water on?
Wiki User
∙ 16y ago
Yes and what is the question?
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
We just had a new bathtub faucet installed and it leaks. The plumber claims it is due to low water pressure. Is that true?
No, too high of water pressure causes problems.
Why the shower head still leaks when turn off the water?
The valve in the shower control needs to be renewed.
88 6CYL jeep Cherokee put mechanical pressure gauge on block pressure is at 6lbs no oil leaks installed new oil pump and still at 6lbs pressure any suggestions?
Engine cam, rod, or main bearings are worn out.
What happens to gas particles when air leaks out in an inflated ball?
Gas particles travel from an area of higher pressure to lower pressure when air leaks out of an inflated ball.
To locate leaks which of the following should be built up in all part of the system the heat the pressure or the oil pressure?
the pressure
When do you change an ac pressure switch (clk320)?
When it leaks or fails to work.
What is a duct blasting test?
A test to determine if there are leaks in your duct system. Pressure is added with a fan to the duct and measured to see if leaks are present, fog can be used to visually identify leaks.
How do you fix leaks in newly installed faucets?
If the leaks are at the water connections you might need to add Teflon tape before you tighten the connections. If you did add the tape, you might need to add more.
What can be used to check for leaks on the pressure side of a turbocharger system?
Soapy Water
The old tub spout water still runs when the shower is turned on?
Either you don't have the knob pulled all the way, or the disc in the spout is faulty.
Shower head leaks when you turn on the water?
tighten the nuts and bolts and clean the heads with crl or soap scum remover- or replace
How do you find a link in the shower?
First put a stooper in the drain, then take a 5 gallon pail of water fill the base of the showe let it stand over night and see if anything leaks ( GET THE WATER FROM AOTHER PLACE NOT FROM THE SHOWER) The next day let the water drain this should let you know if it the shower pan /drain pipe. If not leaks then test the grouting by hahing water spashed on it THEN ids still no leak we can explain how to test the shower valve Sylvan Tieger,LMP
