Sounds like the coil. The high side of the coil should be 35~70 kilo volts. 11 volts will not jump the spark gap. http://www.marksatterfield.com
Make sure that the wires are correctly routed, plugs are good and fuel injectors are correct resistance and working.
I was not aware that headgaskets were repairable. I have always replaced them with new gaskets. If you mean who replaces headgaskets, then that would be an engine mechanic.
i had to have my gaskets replaced ... ive heard the 3100 are known for being made with plastics gaskets ... idk
Head gaskets can't be repaired. If they fail they have to be replaced.
have you had the head gaskets replaced you might have blown head gaskets or warped heads on the block this is a costly repair check your water for oil or check your oil for water this will help to determin if they are ... have you had the head gaskets replaced you might have blown head gaskets or warped heads on the block this is a costly repair check your water for oil or check your oil for water this will help to determin if they are ...
if its leaking from the head gaskets. The gaskets need to be replaced. If you dont have the proper tools it is going to be a huge pain. If leak continues try tightening the bolts around the headers and sparkplugs
No, they can be replaced with the engine in the vehicle, but it is not an easy repair.
Rocker cover gaskets need to be replaced.
Subaru 2.5 liter engine has a problem with head gaskets. If you have not had your head gaskets replaced, that is the first thing I would suspect.
I had the upper intake gaskets replaced at a cost of $181.00 but this also included new spark plugs. Two intake gaskets $18.50
have the heads pulled off and checked for cracks have them resurfaced and sand the block until it looks new. then replaced. gaskets with several layers of sealant on them.
Theoretically, under normal operating conditions, and proper maintenence, intake manifold gaskets should last for the entire life of the vehicle. To my knowledge, there is no prescribed routine replacement interval for intake manifold gaskets. Of course anytime a head(s) is removed, then new gaskets should be used in reassembly.