What is the location of the factory trailer wiring connector for the electric brake control on a 2007 Dodge Ram 1500 with tow package?
The connecting outlet is located under the left side of the dash above the emergency brake. You are looking for a plug in outlet that is color coded blue. The connecting pigtail that you can get from any Dodge dealer will also be blue on the end that you are going to plug in. Connect them together and then you are ready to connect the other end to your electric brake controller.
Is your 2010 dodge ram 1500 bighorn edition with the hemi suppose to have the wiring harness to plug the brake controller into?
if you have a plug on the back of your truck then there is a blue plug over top of the emergency brake pedel on top of the 50 way wire harness and your truck should have came with the plug for the electric brakes in the glove box and the wires are marked as to where they go where you hook them to your trailer brake controller i hope this helps you Allen if…
Where is the stoplight wire to connect an electric brake controller on a 2005 Liberty without the factory towing option?
The wiring is already run for you. It's a simple matter of wiring up the brake controller and installing it in the cabin. Go where ever you comfortably shop (I got mine and Wal-Mart)and get the best controller you can afford. They all work the same but the higher priced unit are more user friendly. Go home and TOPS! Start to finish.
Where is the wiring harness for a electric trailer brake controller on a 2006 gmc envoy Have a factory 7-pin towing harness and can not find on the drivers side under the instrument panel.?
There is no harness persay. It appears that GM didn't put a plug in these vehicles so there is no plug-n-play harnesses. The wires are up in the dash and have to be spliced to a brake controller. A friend found this and sent it along. It shows the wire location and basic installation process. http://www.hobicus.com/bartonmd/Trailblazer%20Brake%20Controller%20Install.pdf
Where is the best place to tie in the brake switch wire from the electric brake controller on the brake switch on a 96 Chevy 1500 silverado?
What is the location of the factory trailer wiring connector to connect an electric brake controller on a 2005 Chevrolet trailblazer with the factory towing package?
I spent a little while yesterday looking around under the dash. I finally found the 4 wires in a bunch on the far left side. They had some electrical tape around them at the ends and then they had a white sticker on them saying what each wire was for. Wire Colors are as follows: Vehicle ************* Brake Controller ORANGE ----- 12 VOLT+ --------- BLACK BLACK ----- GROUND ----------- WHITE LT. BLUE ----- BRK. SWITCH…
What are the colored wires on the 4 way electric brake connector on a 2004 Dodge Ram Truck a 2004 Dodge Ram Truck?
Answer Larger diameter tires will alter your speedometer reading unleds you replace the existing speedometer gearing with on that has the proper ratio. My 2001 Dodge 3500 has 4 wheel anti lock brakes and my speedometer is adjusted with the anti lock brake controller which is programed to the tire size and the rear end gear ratio. If you have this setup you may have to go to the Dodge Dealer to get the controller…
check wiring on your plug make sure the wire on your truck that has power when you press the brakes is connected to the wire for the brakes on the trailer Remember you must have a brake controller installed in the vehicle, just because the vehicle has a "tow package" does not necessarily mean you are ready to tow a trailer with electric brakes. The only vehicles that currently have this capability are the late…