2000 Villager motor mount is located on the cross member dead center front of the vehicle. 2 bolts attached to the cross member pull out towards the alternator as well as the bolt through the mount itself. 17mm if I remember correctly.
At the front of the motor attached to the engine cradle.
Remove the glove box. The front blower motor and the resistor can be accessed from there.
Simply raise the car and support the engine on a jack, then unbolt it.
Technically two. Front and rear. There are two more mounts attached to the transaxle.
front right, rear right and transmission.
3
simple, its a product of ford motor company
Begin by removing the inside door panel of your 2001 Mercury Villager. Remove the window motor wiring harness. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install your new window motor.
There is no fixing a broken motor mount. Replace them with a new ones.
In a repair manual.
Under the dash on the right side.
It's in the lower intake manifold right at the front middle of the engine, near the center fuel injector.