The Camshaft Position Sensor is located under the Rotor within the Distributor. Remove the Distributor Cap (two screws - one in front the other in back), located at the rear of the engine, then remove the Rotor (two screws). The Camshaft Position Sensor is located under the Rotor mounting housing. The engine will need to be turned (hand cranked using a wrench - large nut behind the cooling fan) to position the Rotor mounting housing in the proper location to remove the sensor.
The Camshaft sensor is located in the distributor.
yes, under the rotor in the distributor
It sure can.
The sensor is down on the front of the oil pan just behind the crankshaft pully, which is located at the front of the engine.
It is the only electronic device that is in the distributor. remove the cap and rotor and you will see it.
It's under the the plastic Vortec labeled cover on the top of the engine
It's located in the distributor under the rotor.
Mounted to the throttle body. Opposite side of the throttle lever.
It is on the lower right hand side of the throttle body. There are 2 sensor on that side , it is the lower one.
the crankshaft position sensor is located at the underneath side of the engine right at the bottom of the timing chain cover / front of oil pan
On valley cover plate underneath intake manifold. Must remove intake manifold to get to them.
No cam sensor. Just a crank sensor on the bottom of the timing cover