Top Answer

If you are asking about wheel lug nuts, it is 100 lb/ft.

If you are asking about wheel lug nuts, it is 100 lb/ft.

๐

0๐คจ

0๐ฎ

0๐

0If you are asking about wheel lug nuts, it is 100 lb/ft.

๐

0๐คจ

0๐ฎ

0๐

0its a standard 6 lug i have them on my Tahoe

No they will not fit, Tahoe is 6 lug and navigator is 5 lug.

From my understanding H3 wheels are the same 6 lug patter as say a Chevy 1500 or a Tahoe

The torque spec for lug nuts on a Chevy Impala range from 45 to 65 foot pounds depending on the model year. Each lug nut must be torqued in a cross pattern to ensure even pressure.

pretty sure its 100ft-lbs

My book says 100 lbft.

the torque specs for the Chevy is 100 lbs...pretty much standard for all Chevy cars and small pick up trucks... you silverados torque at 140 lbs

6 lug 5.5 inch or 139.7 mm High Offset

The lug nut torque specs on a 2006 Chevy Malibu is 100 foot pounds. Although that is the factory setting, most service tire shops will tighten to the universal specifications of 90 foot pounds.

2012-14 Chevrolet Orlando lug nut torque spec is 100 ft lbs.

The difference in the number of lugs doesn't have to do with the year, if there's 5 lugs, the Tahoe is 2 wheel drive, if there's 6 lugs it is 4 wheel drive.

The torque for the lug nuts on a cat backhoe 426c depend on what size the lug nuts are; for 1/2 lug nuts the torque should be around 80; for 9/16 lug nuts the torque should be around 140.

If its comming of anything Tahoe sized.. prob not..

It is 140 ft. lb. trust me i work at a tire shop and torque this type of truck everyday

Haynes repair manual specifies 100 ft/lbs.

Torque on the lug nuts is 100 foot lbs.

Lug nut torque 1997 gmc k1500

Lug Nut (Bolt) Torque 110nm (80 ft-lbs)

what is the wheel lug nut torque for 2010 toyota highalnder

The lug nut torque for that 1993 Volvo 960 is 63 ft.lbs.

140 ft./lbs. Source: http://www.discounttire.com/dtcs/infoWheelTorque.dos#chevrolet2

If it's the same gear ratio yes they should fit only if its the same lug count must be a six lug ,Tahoe will not have an 8 lug only suburban 2500 will have them must find out youre gear ratio you can do this by counting youre ring and pinion teeth but most 99 Tahoe should have 3.42 gears there is 14 teeth in the pinionn and 41 in the ring forexample divide 14 by 41 and you get 341.463 round it off to 342 i believe six lug suburbans had 3.73 and if youre Tahoe is 4wd you have to go with whatever is in the rear.

It has a 6 lug bolt pattern but yes you can if the wheel has the correct bolt pattern. It has a 6 lug bolt pattern but yes you can if the wheel has the correct bolt pattern.

yes as long as it a 6 lug

There are a couple of different tools that are good for tightening lug nuts. A torque wrench and a lug wrench are good for tightening lug nuts. Typically lug nuts would be tightened with a torque wrench, but a lug wrench is much cheaper.

Trending Questions

What is the fourth element of the periodic table of elements?

Asked By Wiki User

What is ROBLOX's password on roblox?

Asked By Wiki User

Asked By Wiki User

How do you get 1000000 robux for free?

Asked By Wiki User

Hottest Questions

Previously Viewed

clearAsked By Wiki User

Unanswered Questions

Why does rupaul wear a colostomy bag?

Asked By Wiki User

What is Hugh hefner penis size?

Asked By Wiki User

What is the timbre of the song dandansoy?

Asked By Wiki User

Ano ang kultura at tradisyon ng bansang England o inglaterra?

Asked By Wiki User

Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.