Master Cylinder for brake and clutch are located next to the ABS unit on the firewall of the driver side in the engine bay.
Slave cylinder for clutch is located on the bottom of the transmission.
Under the hood at the top right corner. The brake master cylinder is also there, but the clutch is the smaller of the two.
In the engine compartment near the Master brake cylinder.
On the drivers side of the engine compartment. Between the back side of the plastic intake hose and the brake master cylinder.
You will need a large screwdriver or pry bar, some patience, and a good deal of elbow grease. Be careful not to crack the reservoir when prying on it and it will pop off.
The most probable cause is that the clutch is either not releasing; master/slave cylinder not working, or the clutch itself is damaged.
For master cylinder, lift the hood, look to the top right corner. It's the smaller of the two (brake master cylinder is the other one). The clutch slave cylinder is on the underside of the transmission.
There is no fluid in the clutch....The clutch master cylinder takes DOT 3 brake fluid. It is the same fluid that you put into the brake master cylinder
There were 3,000 Nissan 300zx convertibles made
VG30DETT is in the 90-95 Nissan 300zx. It is a v6
Right at the clutch master cylinder reservoir under the hood.
Yes it will
yes!