The amp in a W208 CLK coupe is located behind the carpeting on the drivers side of the trunk the wiring is as follows: 1. BROWN (big wire): Chassis Ground 2. RED with VIOLET strip (big wire): 12 Volt Ignition/Acc 3. BLUE with WHITE strip: Amp Turn-On (Remote) INPUTS (from Headunit to Amplifier) - 8 THIN wires: 4. GREEN: + Left Front (input) 5. BROWN with GREEN strip: - Left Front (input) 6. ORANGE: + Right Front (input) 7. BROWN with ORANGE strip: - Right Front (input) 8. PINK: + Left Rear (input) 9. BROWN with PINK strip: - Left Rear (input) 10. WHITE: + Right Rear (input) 11. BROWN with WHITE strip: - Right Rear (input) OUTPUTS (from Amplifier to Speakers) - 10 THICK wires: 12. GREEN: + Left Speaker and Tweeter in the Front side of the door (output) 13. BROWN with GREEN strip: - Left Speaker and Tweeter in the Front side of the door (output) 14. ORANGE: + Right Speaker and Tweeter in the Front side of the door (output) 15. BROWN with ORANGE strip: - Right Speaker and Tweeter in the Front side of the door (output) 16. PINK: + Left Speaker in the Back side of the door (output) 17. BROWN with PINK strip: - Left Speaker in the Back side of the door (output) 18. WHITE: + Right Speaker in the Back side of the door (output) 19. BROWN with WHITE strip: - Right Speaker in the Back side of the door (output) 20. GRAY: + Left Speaker(subwoofer) in the rear deck (output) 21. BROWN with GRAY strip: - Left Speaker(subwoofer) in the rear deck (output) 22. VIOLET: + Right Speaker(subwoofer) in the rear deck (output) 23. BROWN with VIOLET strip: - Right Speaker(subwoofer) in the rear deck (output)
there are a number of stereo wires but if you are installing a new stereo, it is worth buying the installation kit.it comes with a harness that will match all wires.
email adubitsky@lightcore.net
Replacing a car stereo is not a difficult process. All you need to do is take off the face plate, unscrew the radio, and unhook the wires. Then place the new stereo in, hook up the wires, screw the new stereo in, and replace the face plate.
To hook up stereo speakers in a truck, attach the stereo wiring to the stereo and run it to the speakers. Clip the stereo speakers into the wires and place them in the panel spaces in the truck.
to my stereo deck
Take the door apart, unscrew the speaker and there are the wires. They run from there to the back of your stereo system. If you pull out your deck you can see the other ends there
kenwood car stereo kdc-mp528 wiring diagrahm
there is a wiring diagram on top of the stereo. you will see it as soon as the stereo is removed
make sure that speaker wires are not touching at all, this causes stereo to cut off
It happened to my Buick after I put in Stereo. The insulation was off one of the stereo wires causing a short which killed my dash lights.The stereo worked.My dash lights didn't.Check your radio wires and make sure its not grounding out.
The 1999 monster truck stereo wiring diagram can be obtained from most Mazda dealerships. The stereo has a wiring harness consisting of five wires.
www.the12volt.com go there, and they have what u need to know.