0
My 87 fiero shifts pretty hard is there a lube you can get and where do you put it?
Wiki User
∙ 12y ago
if its slipping it may be going out or just needs a full trany service. you can get all the stuff at napa
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is a reputable oil change business?
Walmart is pretty reliable. Most dealers are reliable and most independents. Avoid chain lube shops such as Jiffy Lube.
Properties of lube oil?
Depends on the oil and its job!!!. Check out the VibroNurse lube oil pharmacy which gives an explanation of the different properties used in lube oils (www.vibronurse.com). Noria (noira.com is also pretty good) although they want you to give them money!!!
Where to buy lube for women?
Lube is lube and it's not specific for women. You find lube at your local store or pharmacy.
Should you use lube?
ANAL LUBE
What causes a Taurus transmission to shift hard when moving from park to drive or reverse?
check fluid in tranie....and LUCAS tranie lube
What does your cervix feel like when you are not pregnant?
The best I can describe is an inch long rock hard women's nipple (or tit) covered in saliva or lube.
What is Maluba-Lube's population?
Maluba-Lube's population is 21,948.
When was Dura Lube created?
Dura Lube was created in 1986.
When was Mr. Lube created?
Mr. Lube was created in 1976.
Where does the transmission fluid go and what kind does a 1986 Pontiac Fiero 4 speed need?
The lube is added on the upper side of the transmission under the car. The type lube it uses, is listed in your owners manual. I'd remove the VSS (speedometer) housing, and pour it in here. Be care and pull it straight up so you don't knock the gear off and into the tranny. There should be a oil full line on the housing. It uses 5W-30 motor oil.
1984 Pontiac fiero clutch pedal is hard?
if you have already tried to spray lube where the clutch pedal pivots, it is possible that when someone removed the engine the slave cylinder line was pinched or kinked. It is also possible that someone has jacked up the drivers side rocker panel and pinched the line there. try following the line from the slave all the way up to the front. If nothing is visible then it may be the shaft the clutch moves on which requires the removal of the transmission to inspect.
Why is your 5 speed manual trans is hard to put into to any gear?
Check your fluid level, the synchro's are not working, and it may be because theres no lube.
