The Fan is Temperature controlled and will not work till it gets to that temperature. It doesn't run all the time like they did in the old days. If you want to test it simply block the front of the radiator with some cardboard and then run the engine once it starts getting hot the fan should kick in. Good Luck and Remember.
Change Your Mind, Not Your Oil.
Use the First In Synthetic Motor Oil's.
See My Bio For more information.
This may mean there is a weak hose OR some sort of blockage in the radiator or cooling system.
you might want to check for a blown head gasket or a cracked head or block. espically if it loosing water out of the radiator with out leaking on the ground.
Rust and sediment can accumulate in the cooling system. Flushing the radiator helps keep the cooling system clean.
The radiator cap controls cooling system pressure.The radiator cap controls cooling system pressure.
Motor cooling system? The engine cooling system consits of the water pump, radiator, hoses, cooling fans, etc.Motor cooling system? The engine cooling system consits of the water pump, radiator, hoses, cooling fans, etc.
The radiator is part if the cooling system.
there are two metal looking lines that screw into the radiator that is the cooling side
Radiator have metal fins which increases total surface area of the metal body which cooling effect and hence increase the efficiency to maximum cooling effect.
The cooling system.
The radiator is located in front the engine cooling fan and shroud, at the front of the motor. _____________chassis_________________ _____________________________________ Fire wall motor ~cooling fan~ radiator ________________________________________ chassis
yes...
if you have tansmission cooling lines or oil cooling lines that go into the radiator, the cooler in side might have a hole in it.