0
My turn signals don't work on my 1994 Jeep Cherokee Sport but my hazards do. I've checked my all my fuses so what could the problem be?
Wiki User
∙ 16y ago
Did U checked the turn ligths flasher, switch and wiring?
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Why does the turn signals not work on your 1990 geo metro you've replaced switch and checked all bulbs hazards work?
Look at the relay for the flashers, that should fix your problem.
2001 Jeep Cherokee Laredo hazards and turn signals not working to include on dash display any idea where and how to replace hazard flasher?
Check your fuses. Sometimes a fuse can be the cause of a seemingly difficult problem.
1967 Camaro and the turn signals don't work but the hazards do Where would the problem be?
you have a bad turn signal flasher.
The turn signals and hazards lights do not work how do you fix this problem?
Could be the bulbs or the fuses or the flashers or the signal switch assembly
99 ford e-150 the hazards and turn signals stopped working suddenly it isn't the fuse for the turn signals or Hazards as i checked what else could it be?
your fuse is to strong try a lower fuse or some other one is wrong sending too match power that why to blows, or is your headlight cracked?
1997 Mitsubishi Eclipse RS Hazard lights work but turn signals won't?
Your problem is most likely the turn signal relay im having a problem similar to yours but when my signals wont work neither do my hazards
My hazards work but turn signals dont in a 1987 acura integra checked the fuses and the relay but still not working?
It could be the turn signal bulbs, some vehicles use separate bulbs for the hazard and turn signals. It could also be a bad switch or wires for the turn signals.
Why have your turn signals died on your 1991 Pontiac Firebird?
Turn signals just quit working- have replaced flasher- checked all bulbs and fuses, checked all obvious wires, cleaned grounds, replaced the turn signal switch (that was an adventure). At a loss- any help out there? Hazards work fine- all other lights work fine- turn signals dead
What could be the problem when turn signals blink twice then stay off on a 2000 Oldsmobile intrigue?
not sure what causes it, but sometimes my signals will just not work. with lever still in position to activate signal, push button for hazards. then put signal lever in "off" position. turn off hazards. signals should work. temporarily anyway.
What would cause the Turn signals to quit working and all other lights work hazards work also Changed turn signal switch this is for a 1988 GM sierra and Checked all fuses and flasher uit?
Blown fuse or bad flasher unit. Often, cars use different flasher for the turn signals and the flasher, so it is possible for the hazards to work and not the turn signals.
Why would turn signals not work but hazards do after 2 new TS switches and all new fuses and now headlights won't work on low beam?
this may be a relay problem just a guest but the turn signals and the hazards carry separate ts switch on most vehicle (not all)
The turn signals on my 2003 Jeep Cherokee Laredo work and then then don't and then work again while driving.The 4way hazards still work. Any ideas to the question?
If the the problem is not in the actual switch itself, you may have a "flasher" going bad. these run your turn signals and four ways. They are usually located up under the dash some where or close to the fuse or relay boxes.
